SS49

Installation Instructions for the SS49/SS19 Series Analog Position Sensors ISSUE 2 PK 88740 PERSONAL INJURY DO NOT USE these products as safety or emergency stop devices, or in any other application where failure of the product could result in personal injury. Failure to comply with these instructions could result in death or serious injury. SS49/SS19 ELECTRICAL CHARACTERISTICS Supply Voltage Supply Current Output Type Output Voltage @ 0 Gauss, 25°C Sensitivity (measured between -400 and +400 gauss), mV/G Operating Temperature 4 to 10 VDC 4 mA typ. Analog Sourcing 1.75 to 2.25 V @ 5 V Min. 0.60 Typ. 0.90 Max. 1.25 -40 to +100 °C (-40 to 212 °F) SOLDERING/ASSEMBLY SS49 Support leads during any forming/shearing operation. Do not stress leads inside plastic case. Hand soldering - Use 60/40 rosin core solder, and a 399°C (750°F) controlled temperature, 1/8” chisel tip soldering iron. Do not hold iron on terminals for more than four seconds. Lead temperature at package must not exceed 250°C (482°F). Wave soldering - Use Loncoflux 106A35 or equivalent. Set preheaters at 95°C (200°F) for top (component side) of PC board just prior to entering wave. (This may be adjusted depending upon board thickness.) Set solder temperature at 252°C to 260°C max. (485°F to 500°F). Set conveyor speed to about 4.5 feet per minute (1,37 meter/min.), choosing a speed which gives full solder fillets and minimum bridging and icicles. Provide rigid support for the board. SS19/SS19T MICRO SWITCH rec...