2-DOOR CONTROLLER
Edition 12/2005
DG502U/A DG502U/P
2-DOOR CONTROLLER 500 USERS
1 4
2 5 8 0
3 6 9
D’UTILISATION
Warning
Do not use a...
Description
Edition 12/2005
DG502U/A DG502U/P
2-DOOR CONTROLLER 500 USERS
1 4
2 5 8 0
3 6 9
D’UTILISATION
Warning
Do not use a switching power supply because of the interference radiation that may disturb the reading of the badges Ne pas utiliser d’alimentation à découpage à cause de strike rayonnements parasites pouvant perturber la lecture des badges.
V1
12 3 ST1
7 …
RL2
#
RL1
R C T R C T S S B M E 1 2 3 4 5 6 12 V 12 V
PB1
M A G N E T
PB2
V2
ET
Input voltage 12VAC/DC
MONTAGE
Terminal B E M R C T V1,V2 ST1 S,S
Description Request-to-Exit input 1 Request-to-Exit input 2 Common REX inputs N/C Contact door Common N/O Contact door Varistor Jumper for reset Tamper Switch output
NOTICE
DE
This device comes with a varistor. The varistor must be connected to the strike terminal (electromagnet…) operated by the device. If this product works with many strikes, each of them should have a varistor. The varistor controls the overload produced by the strike coil – self-effect. If you are using a « Shear Lock » electromagnetic lock, it is recommended to use a separate power supply than the one connected to the DG502U!
Edition 12/2005
Technical specifications
Input voltage Outputs Tamper switch Cardholders Master code Inputs Controller Distance between the remote readers and the controller 12 VAC/DC 2 form C relays N/O and N/C 3A @ 125V 500 MA @ 50 VAC/DC 500 badges 5-digit master code 2 REX inputs 12-digit keypad with built-in buzzer (Audible feedback) 60 cm minimum, 50 mete...
Similar Datasheet