GPS Receiver RF Front End
GP2010
GPS Receiver RF Front End
Supersedes edition in August 1996 Global Positioning Products Handbook, HB4305-1.0 DS40...
Description
GP2010
GPS Receiver RF Front End
Supersedes edition in August 1996 Global Positioning Products Handbook, HB4305-1.0 DS4056 - 3.4 October 1996
The GP2010 is Mitel Semiconductor second generation RF Front-end for Global Positioning System (GPS) receivers. The GP2010 uses many innovative design techniques and a leading-edge bipolar process to offer a low power, low cost and high reliability RF Front End solution . The GP2010 is designed to operate from either 3 or 5 Volt power supplies. The input to the device is the L1 (1575.42MHz) CoarseAcquisition (C/A) code Global Positioning signal from an antenna (via a low-noise pre-amplifier). The output is 2-bit quantised for subsequent signal processing in the digital domain. The GP2010 contains an on-chip synthesiser, mixers, AGC and a quantiser which provides Sign and Magnitude digital outputs. A minimum of external components is required to make a complete GPS front-end. The device has been designed to operate with the GP2021 12-channel Global Positioning Correlator, and DW9255 SAW filter, both also available from Mitel Semiconductor. Pin 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22
23 24 25 26 27 28 29 30 31 32 33
22 21 20 19 18 17 16 15 14 13 12
34 35 36 37 38 39 40 41 42 43 44
GP2010
GP44
Name
Name IF Output PLL Filter 1 PLL Filter 2 VEE (OSC) VCC (OSC) VEE (OSC) VEE (REG) PRef PReset VEE (IO) CLK MAG SIGN OPC IKOPC IK+ VDD (IO) PDN TEST LD VEE (DIG) AGC AGC +
11 10 9 8 7 6 5 4 3 2 1
Pin 23 24 25 26 27 28 29 3...
Similar Datasheet