Constant frequency charge pump DC/DC converter
General Description The ET9366 is a low noise, constant frequency charge pump DC/DC converter for white LED applications...
Description
General Description The ET9366 is a low noise, constant frequency charge pump DC/DC converter for white LED applications. The ET9366 is capable of driving up to six channels of LEDs at preset 25mA per channel from a 2.5V to 6.0V input. The current sinks may be operated individually parallel for driving higher current LEDs. Only one 0.47μF flying capacitors and two small 1μF capacitors (at Vcc and Vout) make this part ideally suited for small, batterypowered applications. The serial digital input is used to enable, disable, and set current for each LED with 16 settings down to 1.5mA. Each output of the ET9366 is equipped with builtin softstart circuitry prevents excessive inrush current during startup. A low current shutdown feature disconnects the load from the input and reduces quiescent current to less than 1μA. The ET9366 is available in a Pbfree, spacesaving 3.0×3.0mm 16pin QFN16 package.
Features
VIN Range: 2.5V to 6.0V Fully Programmable Current with Single Wire——16 Current Levels Drives up to Six Channels of LEDs Overcurrent and Overtemperature Protected No Inductors, Low Noise Operation Small Application Circuit Automatic Soft Start I Q <1μA in Shutdown Undervoltage Lockout with Hysteresis Package:3.0×3.0mm QFN16
Applications
Cell Phone/Smart Phone/PDA Mp3/Mp4/PMP White LED Backlighting
Pin Configuration
...
Similar Datasheet