Document
S8810MG
TECHNICAL DATA
Infrared Laser Diode
Features • Mode Structure: single mode, edge emitting • Peak Wavelength : typ. 880 nm • Optical Ouput Power: 10 mW • Package: 5.6 mm • Ridge width 1x5 µm
Electrical Connection
Pin Configuration
n-type PIN Function 1 LD Cathode 2 LD Anode, PD Cathode 3 PD Anode
Bottom View
Absolute Maximum Ratings (TC=25°C)
Item CW Output Power LD Reverse Voltage PIN PD Reverse Voltage Operating Case Temperature Storage Temperature
Symbol
PO VrLD VrPIN TC Tstg
Value 10 2 30
-10 … +60 -15 … +85
Specifications (TC=25°C, PO=10mW)
Item
Symbol
Min.
Typ.
Optical Specifications
Center Wavelength FWHM Beam Divergence*
Electrical Specifications
λC 870 880 θ║ 8 12 θ┴ 28 38
Threshold Current Operating Current Slope Efficiency
Ith - 10 Iop - 29 η 0.3 0.5
Operating Voltage Monitor Current
Uop - 2.2
Im 0.2
-
* θ║ and θ┴ are defined as the angle within the intensity is 50% of the peak value. The above specifications are for reference purpose only and subjected to change without prior notice.
Max.
890 15 45
15 35 2.5 0.6
Unit mW
V V °C °C
Unit
nm deg deg
mA mA mW/mA V mA
19.04.2012
S8810MG
1 of 5
Package Dimensons
5.6 mm Package (Unit:mm)
Typical Performance Curves
Optical Ouput Power vs. Forward Current
19.04.2012
S8810MG
2 of 5
Forward Voltage vs. Forward Current Peak Wavelength vs. Case Temperature
Far-Field Pattern
19.04.2012
S8810MG
3 of 5
Monitor Current vs. Optical Output Power Slope Efficiency vs. Case Temperature
Threshold Current vs. Case Temerature
19.04.2012
S8810MG
4 of 5
Safety of Laser light
• Laser Light can damage the human eyes and skin. Do not expose the eye or skin directly to any laser light and/or through optical lens. When handling the LDs, wear appropriate safety glasses to prevent laser light, even any reflections from entering to the eye. Focused laser beam through optical instruments will increase the chance of eye hazard.
• These LDs are emitting invisible light.
Cautions
1. Operating methode • This LD shall change its forward voltage requirement and optical ouput power according to temperature change. Also, the LD will require more operation current to maintain same ouput power as it degrades. In order to maintain output power, use of APC (Automatic Power Control) is recommended. Which use monitor feedback to adjust the operation current. • Confirm that electrical spike current generated by swithing on and off does not exceed the maximum operating current level specified herein above as absolute maximum rating. Also, employ appropriat countermeasures to reduce chattering and/or overshooting in the circuit.
2. Static Electricity • Static electricity or electrical surges will reduce and degrade the reliability of the LDs. It is recommended to use a wrist trap or anti-electrostatic glove when handeling the product.
3. Absolute Maximum Rating • Active layer of LDs shall have high current density and generate high electric field during its operation. In order to prevent excessive damage, the LD must be operated striclty below absolute maximum rating.
19.04.2012
S8810MG
5 of 5
.