Dynamic Differential Hall Effect Sensor
Data Sheet Supplement Version 1.1
Dynamic Differential Hall Effect Sensor
TLE4927C
For all parameters not specified i...
Description
Data Sheet Supplement Version 1.1
Dynamic Differential Hall Effect Sensor
TLE4927C
For all parameters not specified in this document the TLE4925C data sheet is valid.
PG-SSO-3-9
Type TLE4927C
Marking 27C
Ordering Code SP000373702
Package PG-SSO-3-9
Page 1 of 5
TLE4927C supplement
1. Magnetic Characteristics in Running Mode
Minimum signal amplitude
∆Bmin
0.35 0.75 1.35
mT
Page 2 of 5
TLE4927C supplement
Pin 3 (Q)
S (N) N (S)
B2 B1
Crankshaft Wheel Profile
Pin 1 (Vs) Branded Side
Magnetic Field Difference
∆B=B1-B2
∆BENOP
∆BENRP
Small airgap
Large airgap
Hidden Adaptive Hysteresis
Output Signal VQ
Enabling point for releasing output: B1-B2<∆BENRP. Next zero crossing switches the output OFF (VQ=HIGH). Enabling point for operate point: B1-B2>∆BENOP. Next zero crossing switches the output ON (VQ=LOW). ∆BHYS=|∆BENOP-∆BENRP| Outside of a permanent magnet the magnetic induction (=flux density) points from north to the south pole. It is common to define positive flux if the south pole of a magnet is on the branded side of the IC. This is equivalent to the north pole of the magnet on the rear side of the IC.
Figure 1 System operation with hidden adaptive hysteresis
Page 3 of 5
TLE4927C supplement
2. Typical Hysteresis Values
PGA
X1 X2 X4 X8 X16 X32 X64
GainRange
6 5 4 3 2 1 0
Hysteresis (peak to peak) 13.5 mT 10.12 mT 6.75 mT 4.5 mT 3 mT 2 mT 1.5mT
FullRange =MaxSignal ±120mT ±60mT ±30mT ±15mT ±7,5mT ±3,75mT ±1,875mT
Percentage thresholds 5,625% 8.433...
Similar Datasheet