NCV7381
FlexRay) Transceiver, Clamp 30
NCV7381 is a single−channel FlexRay bus driver compliant with the FlexRay Electr...
NCV7381
FlexRay) Transceiver, Clamp 30
NCV7381 is a single−channel FlexRay bus driver compliant with the FlexRay Electrical Physical Layer Specification Rev. 3.0.1, capable of communicating at speeds of up to 10 Mbit/s. It provides differential transmit and receive capability between a wired FlexRay communication medium on one side and a protocol controller and a host on the other side.
NCV7381 mode control functionality is optimized for nodes permanently connected to car battery.
It offers excellent EMC and ESD performance.
KEY FEATURES General
Compliant with FlexRay Electrical Physical Layer Specification
Rev 3.0.1
FlexRay Transmitter and Receiver in Normal−power Modes for
Communication up to 10 Mbit/s
Support of 60 ns Bit Time FlexRay Low−power Mode Receiver for Remote Wakeup Detection Excellent Electromagnetic Susceptibility (EMS) Level over Full
Frequency Range. Very Low Electromagnetic Emissions (EME)
Bus Pins Protected against >10 kV System ESD Pulses Safe Behavior under Missing Supply or No Supply Conditions Interface Pins for a Protocol Controller and a Host
(TxD, RxD, TxEN, RxEN, STBN, BGE, EN, ERRN)
INH Output for Control of External
Regulators Local Wakeup Pin WAKE TxEN Time−out BGE Feedback Supply Pins VBAT, VCC, VIO with Independent Voltage Ramp Up:
♦ VBAT Supply Parametrical Range from 5.5 V to 50 V ♦ VCC Supply Parametrical Range from 4.75 V to 5.25 V ♦ VIO Supply Parametrical Range from 2.3 V to 5.25 V
Compatible with 14 V and 28 ...