RS422-module
®
AX1011
AX1011
RS422-module for AP1003
Installation sheet
GENERAL The AX1011 is intended to connect certain XS-cont...
Description
®
AX1011
AX1011
RS422-module for AP1003
Installation sheet
GENERAL The AX1011 is intended to connect certain XS-controllers (MD300 loop) to AEOS (AP1003). The XS controllers are changed in such a way that their Inputs/Outputs behave exactly like AEpack In/Outputs. This means that a full functional AEOS system can be built utilizing existing XS hardware. The AX1001 is connected to the AP1003 (only suitable for the upper connector). The RS232 signal of the AP1003 is converted to an isolated RS422 signal, which is used to connect an MD300 loop of XS controllers. To connect the XS Controller loop to AEOS using the AX1011 special firmware is required at the AP1003 and the connected XS-controllers in the MD300 loop.
CONNECTIONS Place the AX1011 at the upper connector of the AP1003. The original signals of the AP1003 (except for Tx1,GND and Rx1) are lead to the screw connector of the AX1011.
Attention: Signals of pin 8 and higher are at the AX1011 located at another pin than the original AP1003 (see figure below).
AP1003 connectors
Vlock
NC RY1
*
CROYM1 *
NO RY1
*
IN1
GND
IN3
Tx1 GND Rx1
+5V out
+12V out
1 2 3 4 5 6 7 8 9 10 11 12
GND
NC RY2
COM RY2
NO RY2
IN2 GND IN4
Tx2 GND Rx2
RDP RCP
UL* NA*
13 14 15
UL GND NA
16
CLS
AX1011
Rx Tx
Pow
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
Vlock
NC RY1
COM RY1
NO RY1
IN1 GND IN3
Tx+
Tx-
Rx+
Rx-
+5V +12V out out
UL* NA*
AX1011 connector
MD300 board at XS-controller
Cable shield to GND and metal case
R...
Similar Datasheet