RS232 to RS422/485 converter
®
AX1012
AX1012
RS232 to RS422/485 converter for AEpacks
Installation sheet
GENERAL The AX1012 is a RS232 to RS422/R...
Description
®
AX1012
AX1012
RS232 to RS422/485 converter for AEpacks
Installation sheet
GENERAL The AX1012 is a RS232 to RS422/RS485 converter, intended to connect external readers using RS422 or 485 to AEpacks (using RS232). Both RS422 and RS485 are NON-isolated. The AX1012 is mounted on the RS232 connector points of the corresponding AEpack. Power supply (+5VDC) for the AX1012 is connected by a separate wire from the AX1012 to the AEpack. Connection point for the +5V power supply differs per type AEpack (check always the AEpack installation sheet for detailed information). RS422 or RS485 selection is made by a jumper. Remark: For integrating AEOS with XS-Accessors always use the AX1011 (connected to AP1003)
CONNECTIONS AX1012 Place the AX1012 at the RS232 connector-points of the AEpack and connect the power-supply lead to the correct connector of this AEpack (AEpack depending!)
RS422: RS485:
Use Tx+, Tx-, Rx+ and RxSet jumper to RS422 Use only Rx+ and RxSet jumper to RS485
Peripheral connections:
RS422 AX1012 Device
Tx+ Rx+ Tx- RxRx+ Tx+ Rx- Tx-
RS485 AX1012 Device
--Rx+ A Rx- B
485 422 485 422 485 422
AEpack To AEpack RS232 +5V Tx GND Rx
Rx GND Tx
+5V
Power supply lead
Tx+ Tx- Rx+ Rx-
RS422 Out RS422 In RS485 In/Out
External device
JUMPER SETTINGS: RS422 or RS485 can be selected
CABLE SHIELDING: Use always shielded cables: cable shield must be connected to protective ground.
Date : 02 September 2005
Part.no.: 5258480
This information is furnished for guidance, and with ...
Similar Datasheet