LC898113

LC898113 CMOS LSI Optical Image Stabilization (OIS) Controller & Driver www.onsemi.com Overview The LC898113 is device integrating digital gyro interface, gyro filter, stepping motor control circuit, and motor driver functions needed to implement an Optical Image Stabilization (OIS) system using stepping motors. These functions make it possible to build a system using a minimal software program that enables the host microcontroller to turn Optical Image Stabilization (OIS) on and off, for example. The gyro filter coefficients may be set to any values by the host microcontroller, making it possible to build filter circuits optimized for the system. The LC898113 integrates a signal determination circuit for pan/tilt processing and a filter circuit, enabling implementation of a variety of processing in response to camera movements. The LC898113 integrates four saturation-drive H-bridge channels for stepping motor drive, and PWM drive with 1-2phase control to 8W1-2-phase control is supported. Also integrated are a photo sensor drive circuit for control object position detection (for example, a CMOS sensor), a position determination circuit, and a circuit for moving to the optical center based on the results from the preceding circuits. Thus, the host microcontroller can specify detection start and the LC898113 will automatically move the control object to the initial position. Both SPI and I2C are supported as serial interfaces for communication with the host microcontroller. T...