NCP392D
Adjustable Front End Overvoltage Protection Controller with Protected Vbus Output
The NCP392D is an overvoltage...
NCP392D
Adjustable Front End Overvoltage Protection Controller with Protected Vbus Output
The NCP392D is an overvoltage front end protection controller and is able to disconnect the systems from its output pin in case wrong input operating conditions are detected, up to +28 V. Thanks to this device using internal NMOS, no external device is necessary, reducing the system cost and the PCB area of the application board.
Internal OVLO threshold is available, or can be adjusted if an external resistor bridge is used.
At power up (EN pin = low level), the Vout turns on tstart time after internal timer elapsed.
The NCP392D features an ACOK pin that indicates faulty condition.
Features
Over−voltage Protection Up to + 28 V On−chip Low RDS(on) NMOS
Transistors: Typical 34 mW Over−voltage Lockout (OVLO) Externally Adjustable OVLO Internal 15 ms Startup Delay Shutdown EN Input ACOK Status Pin + 100 V Surge Capability, in Compliance with IEC61000−4−5
Standard
Compliance to IEC61000−4−2 (Level 4) Standard
8 kV (Contact) 15 kV (Air)
ESD Ratings:
Machine Model = B (200 V) Human Body Model = 2 (2 kV)
CSP−12 Package 1.3 x 2.0 mm, 0.4 mm Pitch This is a Pb−Free Device
Typical Applications
Cell Phones Tablets Camera Phones Digital Still Cameras Personal Digital Applications
www.onsemi.com
MARKING DIAGRAM
WLCSP 12 FCC SUFFIX CASE 567JM
392DR AYWW
G
392DR = Specific Device Number A = Assembly Location Y = Year WW = Work Week G = Pb−Free Package
PIN CONNECT...