Slew-Rate-Limited RS-485/RS-422 Transceivers
TECHNICAL DATA
Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers
ILX75176
Description The ILX75176 is low-power...
Description
TECHNICAL DATA
Low-Power, Slew-Rate-Limited RS-485/RS-422 Transceivers
ILX75176
Description The ILX75176 is low-power transceivers for RS-485
and RS- 422 communication. IC contains one driver and one receiver.
The driver slew rates of the ILX75176 is not limited, allowing them to transmit up to 10 Mbps.
These transceivers draw between 120µA and 500µA of supply current when unloaded or fully loaded with disabled drivers. All parts operate from a single 5V supply. Drivers are short-circuit current limited and are protected against excessive power dissipation by thermal shutdown circuitry that places the driver outputs into a highimpedance state.
The receiver input has a fail-safe feature that guarantees a logic-high output if the input is open circuit. The ILX75176 is designed for half-duplex applications.
ILX75176N DIP 8 ILX75176D SOP 8
ORDERING INFORMATION
Features
Device
ILX75176N ILX75176D ILX75176DT
Operating Temperature Range
TA = 0 to 70 C
Package
DIP8 SOP8 SOP8
Shipping
Tube Tube Tape & Reel
Low Quiescent Current: 300µA -7V to +12V Common-Mode Input Voltage Range Three-State Outputs 50ns Propagation Delays, 5ns Skew Half-Duplex Versions Available Operate from a Single 5V Supply Allows up to 32 Transceivers on the Bus Data rate: 10 Mbps Current-Limiting and Thermal Shutdown for Driver Overload Protection Enhanced ESD Specifications:
±15kV IEC61000-4-2 Air Discharge ±8kV IEC61000-4-2 Contact Discharge
Pin Description
2012, February, ver....
Similar Datasheet