NFC/RFID Module
1
Tech Support: support@iteadstudio.com
RDM8800 NFC/RFID Module
Overview
RDM8800 card reader is a module based on PN532...
Description
1
Tech Support: support@iteadstudio.com
RDM8800 NFC/RFID Module
Overview
RDM8800 card reader is a module based on PN532 chip customized for 13.56MHz NFC RFID card, compatible with RDM6300 interface, which can read data directly from the serial interface.
Unlike ordinary RFID modules, RDM8800 integrates LGT8FF8A chip, compatible with Arduino library, thus we can modify the firmware to suit our own needs. Itead Studio also released the source codes of RDM8800 firmware, and users can make secondary development based on it.
Specifications
PCB size Input voltage Interface Compatibility
Baud rate
38.1mm X 117.78mm X 1.6mm 5V UART With ISO 14443 Type A protocol With ISO 14443 Type B[1] protocol 9600
RDM8800 NFC/RFID Module
iteadstudio.com
10th, Dec., 2013
2
Tech Support: support@iteadstudio.com
[1]: Version 1.0 firmware does not support ISO 14443 Type B at present, which requires users to make secondary
development.
Electrical characteristics
Parameter Supply voltage Consumption current (average) Logic input voltage
Hardware
Min. 4.8 Vss-0.3
Typical 5 80 3.3
Max. 5.5 5
Unit VDC mA VDC
pinmap
Pin Pin1
P1 Pin2 Pin3
RDM8800 NFC/RFID Module
Pin name +5V(DC)
GND NC
iteadstudio.com
Description Power input
Ground Unoccupied
10th, Dec., 2013
3
Tech Support: support@iteadstudio.com
Pin4 Pin5 Pin1 P2 Pin2 Pin3 Pin1 P3 Pin2 Pin1 Pin2 Pin3 P4 Pin4 Pin5 Pin6
RX(TTL) TX(TTL)
LED +5V(DC)
GND ANT1 ANT2 SWD 3.3V SWC
NC RST GND
UART input UART output Interrupt pin Power output
Gro...
Similar Datasheet