G5196

G5192X : The G5192C/D is a family of high-side load switches designed to operation from 1.5V to 5V input voltage. The load switch pass element is an internal 25 ohm RON P-channel MOSFET which enable the device to support up to 3A of continuous current. Additiona.

G5193 : The G5193 device is a full featured 5.5V, 3A synchronous step down current mode converter with two integrated MOSFETs. The G5193 enables small designs by integrating the MOSFETs, implementing current mode control to reduce external component count, reducing inductor size by enabling up to 2MHz switching frequency, and minimizing the IC footprint with a small 3mm x 3mm thermally enhanced QFN package. The G5193 provides accurate regulation for a variety of loads with an accurate ±1% Voltage Reference (VREF) over temperature. Efficiency is maximized through the integrated 45mΩ MOSFETs and 350µA typical supply current. Using the enable pin, shutdown supply current is reduced to 2µA by entering a.

G5197 : The G5197 advanced load-management switches target applications requiring a highly integrated solution. If disconnects loads powered from DC power rail (6V) with stringent off-state current targets and high load capacitances (up to 200µF). Each switch consists of slew-rate controlled low-impedance MOSFET switch (23mΩ type) and other integrated analog features. The slew-rate controlled turn-on characteristic prevents inrush curr.

G5198 : The G5198 is a N-channel MOSFET power switch designed for high-side load-switching applications, and the device has a typical RDS(ON) of 12m and the output current is limited to 9A.The G5198 has a programmable turn-on load switch and offers a shutdown load discharge circuit to rapidly turn off a load circuit when the switch is disabled. The G5198 operates with an input voltage ranging from 0.6V to 5.5V. The G5198 also features an under voltage lock out which turns the switch off when an in.

G5199 : The G5199 is a high performance AC/DC power supply controller which uses digital control technology to build peak current mode PWM flyback power supplies. The device operates in quasi-resonant mode to provide high efficiency along with a number of key built-in protection features while minimizing the external component count, simplifying EMI design and lowering the total bill of material cost. The G5199 removes the need for secondary feedback circuit while achieving excellent line and load regulation. It also eliminates the need for loop compensation components while maintaining stability over all operating conditions. Pulse-by-pulse waveform analysis allows for a loop response that is much .