DatasheetsPDF.com

ATmega328P


Part Number ATmega328P
Manufacturer ATMEL
Title 8-bit Microcontroller
Description 1.1.1 VCC Digital supply voltage. 1.1.2 GND Ground. 1.1.3 Port B (PB7:0) XTAL1/XTAL2/TOSC1/TOSC2 Port B is an 8-bit bi-directional I/O port w...
Features
● High performance, low power AVR® 8-bit microcontroller
● Advanced RISC architecture
● 131 powerful instructions
  – most single clock cycle execution
● 32  8 general purpose working registers
● Fully static operation
● Up to 16MIPS throughput at 16MHz
● On-chip 2-cycle multiplier
● High endurance n...

File Size 8.19MB
Datasheet ATmega328P PDF File






Similar Datasheet

ATmega328 : ....9 2. Configuration Summary. 10 3. Ordering Information ..... 11 3.1. ATmega328 . 11 3.2. ATmega328P .....12 4. Block Diagram......

ATmega328 : ..... 13 2 Overview 15 2.1 Block Diagram . 15 2.2 Comparison Between Processors . 16 3 Resources .. 17 4 Data Retention ....

ATMEGA328A : VCC Digital supply voltage. GND Ground. Port B (PB7:0) XTAL1/XTAL2/TOSC1/TOSC2 Port B is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port B output buffers have symmetrical drive characteristics with both high sink and source capability. As inputs, Port B pins that are externally pulled low will source current if the pull-up resistors are activated. The Port B pins are tri-stated when a reset condition becomes active, even if the clock is not running. Depending on the clock selection fuse settings, PB6 can be used as input to the inverting Oscillator amplifier and input to the internal clock operating circuit. Depending on the clock selection.

ATmega328P : ..... 13 2 Overview 15 2.1 Block Diagram . 15 2.2 Comparison Between Processors . 16 3 Resources .. 17 4 Data Retention ....

ATmega328PB : ..10 2. Configuration Summary. 11 3. Ordering Information12 4. Block Diagram... 13 5. Pin Configurations... 14 5.1. Pin Descriptions.....

ATmega328V : VCC Digital supply voltage. 1.1.2 GND Ground. 1.1.3 Port B (PB7:0) XTAL1/XTAL2/TOSC1/TOSC2 Port B is an 8-bit bi-directional I/O port with internal pull-up resistors (selected for each bit). The Port B output buffers have symmetrical drive characteristics with both high sink and source capability. As inputs, Port B pins that are externally pulled low will source current if the pull-up resistors are activated. The Port B pins are tri-stated when a reset condition becomes active, even if the clock is not running. Depending on the clock selection fuse settings, PB6 can be used as input to the inverting Oscillator amplifier and input to the internal clock operating circuit. Depending on the.




Since 2006. D4U Semicon,
Electronic Components Datasheet Search Site. (Privacy Policy & Contact)