| Part Number | MIC826 |
| Manufacturer | Microchip |
| Title | Voltage Supervisor |
| Description | The MIC826 is a low-current, ultra-small, voltage supervisor with manual reset input, watchdog timer, and active-high and active-low push-pull out... |
| Features |
• Precision 1.8V to 5V Power Supply Monitor • ±0.5% Threshold Accuracy at TA = +25°C • ±1.5% Threshold Accuracy from TA = –40°C to +125°C • 3.8 µA Supply Current (MIC826S/R/T/W/Y/Z) • 4.8 µA Supply Current (MIC826L/M) • Manual Reset Input • 140 ms (min.) Reset Timeout Period • 1.6s (typ.) Watchdog T... |
| File Size | 1.67MB |
| Datasheet |
|
MIC820 : The MIC820 is a rail-to-rail output, operational amplifier in Teeny™ SC70 packaging. The MIC820 provides 5MHz, -3dB bandwidth while consuming an incredibly low 22µA supply current. The SC70 packaging achieves significant board space savings over devices packaged in SOT-23 or MSOP-8 packaging. The SC70 occupies approximately half the board area of a SOT-23 package. Features • • • • • • • • Teeny™ SC70 packaging 5MHz, –3dB bandwidth product 4MHz gain-bandwidth product 22µA supply current Rail-to-Rail output Ground sensing at input common mode to GND Common mode to GND Drive large capactive loads Applications • Portable equipment Ordering Information Part Number MIC820BC5 Marking Junction T.
MIC826 : The MIC826 is a low-current, ultra-small, voltage supervisor with manual reset input, watchdog timer, and active-high and active-low push-pull outputs. The reset outputs are asserted and held when the supply voltage falls below the factory-programmed threshold voltage, when the /MR pin is pulled low, or if the watchdog times out. Reset is asserted for the reset timeout delay after the supply voltage increases above the rising threshold voltage or when manual reset input is asserted high. The MIC826 features an integrated pull-up resistor on the /MR. An active-low push-pull reset output (/RESET) and an active-high reset output (RESET) provide flexibility when interfacing with various microcon.