MCP2510 Stand-Alone CAN Controller with SPI® Interface FEATURES • Implements Full CAN V2.
0A and V2.
0B at 1 Mb/s - 0 - 8 byte message length - Standard and extended data frames - Programmable bit rate up to 1 Mb/s - Support for remote frames - Two receive buffers with prioritized message storage - Six full acceptance filters - Two full acceptance filter masks - Three transmit buffers with prioritization and abort features - Loop-back mode for self test operation • Hardware Features - High Speed SPI Interface (5 MHz at 4.
5V I temp) - Supports SPI modes 0,0 and 1,1 - Clock out pin with programmable prescaler - Interrupt output pin with selectable enables - ‘Buffer full’ output pins configureabl...

Since 2006. D4U Semicon,
Electronic Components Datasheet Search Site. (Privacy Policy & Contact)