MCP2561/2
High-Speed CAN Transceiver
Features:
• Supports 1 Mb/s Operation
• Implements ISO-11898-5 Standard Physical Layer Requirements
• Very Low Standby Current (5 µA, typical) • VIO Supply Pin to Interface Directly to
CAN Controllers and Microcontrollers with 1.
8V to 5.
5V I/O
• SPLIT Output Pin to Stabilize Common Mode in Biased Split Termination Schemes
• CAN Bus Pins are Disconnected when Device is Unpowered
- An Unpowered Node or Brown-Out Event will Not Load the CAN Bus
• Detection of Ground Fault: - Permanent Dominant Detection on TXD - Permanent Dominant Detection on Bus
• Power-on Reset and
Voltage Brown-Out Protection on VDD and VIO Pin
• Protection Against Damage Due to Short-C...