DatasheetsPDF.com

SP3497E

Exar Corporation
Part Number SP3497E
Manufacturer Exar Corporation
Description (SP3495E - SP3497E) 3.3V High Speed RS-485/RS-422 Transceivers
Published Jun 22, 2009
Detailed Description SP3495E-3497E HIGH SPEED +3.3V RS-485/RS-422 TRANSCEIVERS WITH +/-15KV ESD PROTECTION AND ADVANCED FAILSAFE www.DataShee...
Datasheet PDF File SP3497E PDF File

SP3497E
SP3497E

Overview
SP3495E-3497E HIGH SPEED +3.
3V RS-485/RS-422 TRANSCEIVERS WITH +/-15KV ESD PROTECTION AND ADVANCED FAILSAFE www.
DataSheet4U.
com MAY 2009 REV.
1.
0.
0 GENERAL DESCRIPTION The SP3495E - SP3497E transceivers are suitable for high speed bidirectional communication on multipoint bus transmission lines.
They are designed for balanced data transmission and comply with both RS-485 and RS-422 EIA standards.
Each device contains one differential driver and one differential receiver Driver differential outputs and receiver differential inputs are connected internally to form a half-duplex input/output to the RS-485 bus.
Separate RE and DE pins enable and disable the driver and receiver independently or may be externally connected together as a direct control.
The device enters a low power shutdown mode if both driver and receiver are disabled.
the bus-pin outputs of disabled or powered down devices are in high impedance state.
The high impedance driver output is maintained over the entire common-mode voltage range of -7V to +12V.
SP3495E - SP3497E operates from a single 3.
3V power supply.
SP3495E - SP3497E transceivers load the data bus only half as much as a standard RS-485 unit load.
This allows up to 64 devices to be connected simultaneously on a bus without violating required RS-485 signal margin and without using repeaters.
Excessive power dissipation caused by bus contention or by shorting outputs to ground or a voltage source is prevented by short circuit protection and thermal shutdown.
This feature forces the driver output into high impedance state if the absolute value of the output current exceeds 250mA or if junction temperature exceeds 165°C.
Receivers will fail-safe to a logic high output state if the inputs are unconnected (floating) or shorted.
All RS-485 inputs FIGURE 1.
TYPICAL APPLICATION CIRCUIT and outputs are ESD protected up to +/-15kV Human Body Model.
FEATURES • 3.
3V Single Supply Operation • High Speed up to 32Mbps • Robust +/-15kV ESD protection • H...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)