DatasheetsPDF.com

MAX9964

Maxim
Part Number MAX9964
Manufacturer Maxim
Description (MAX9963 / MAX9964) ATE Driver/Comparator
Published Oct 21, 2013
Detailed Description 19-2977; Rev 1; 1/04 Quad, Low-Power, 500Mbps ATE Driver/Comparator General Description The MAX9963/MAX9964 four-channe...
Datasheet PDF File MAX9964 PDF File

MAX9964
MAX9964

Overview
19-2977; Rev 1; 1/04 Quad, Low-Power, 500Mbps ATE Driver/Comparator General Description The MAX9963/MAX9964 four-channel, low-power, highspeed pin electronics driver and comparator ICs include, for each channel, a three-level pin driver, a dual comparator, and variable clamps.
The driver features a wide voltage range and high-speed operation, includes high-Z and active-termination (3rd-level drive) modes, and is highly linear even at low-voltage swings.
The dual comparator provides low dispersion (timing variation) over a wide variety of input conditions.
The clamps provide damping of high-speed DUT waveforms when the device is configured as a high-impedance receiver.
High-speed, differential control inputs compatible with ECL, LVPECL, LVDS, and GTL levels are provided for each channel.
ECL/LVPECL or flexible open-collector outputs are available for the comparators.
The A-grade version provides tight matching of gain and offset for the drivers and comparators, allowing reference levels to be shared across multiple channels in cost-sensitive systems.
For system designs that incorporate independent reference levels for each channel, the B-grade version is available at reduced cost.
Optional internal resistors at the high-speed inputs provide differential termination of LVDS inputs, while optional internal resistors provide the pullup voltage and source termination for open-collector comparator outputs.
These features significantly reduce the discrete component count on the circuit board.
Low-leakage, slew rate, and tri-state/terminate controls are operational configurations that are programmed through a 3-wire, low-voltage, CMOS-compatible serial interface.
The MAX9963/MAX9964 operating range is -1.
5V to +6.
5V, with power dissipation of only 825mW per channel.
These devices are available in a 100-pin, 14mm x 14mm body, 0.
5mm pitch TQFP with an exposed 8mm x 8mm die pad on the top (MAX9963) or bottom (MAX9964) of the package for efficient heat removal.
The MAX9963/MAX...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)