Dual-Operational Amplifiers. LM358-N Datasheet


LM358-N Amplifiers. Datasheet pdf. Equivalent


LM358-N


Dual-Operational Amplifiers
Product Folder

Sample & Buy

Technical Documents

Tools & Software

Support & Community

LM158-N, LM258-N, LM2904-N, LM358-N
SNOSBT3I – JANUARY 2000 – REVISED DECEMBER 2014
LMx58-N Low-Power, Dual-Operational Amplifiers

1 Features
•1 Available in 8-Bump DSBGA Chip-Sized Package, (See AN-1112, SNVA009)
• Internally Frequency Compensated for Unity Gain • Large DC Voltage Gain: 100 dB • Wide Bandwidth (Unity Gain): 1 MHz
(Temperature Compensated) • Wide Power Supply Range:
– Single Supply: 3V to 32V
– Or Dual Supplies: ±1.5V to ±16V • Very Low Supply Current Drain (500
μA)—Essentially Independent of Supply Voltage • Low Input Offset Voltage: 2 mV • Input Common-Mode Voltage Range Includes
Ground • Differential Input Voltage Range Equal to the
Power Supply Voltage • Large Output Voltage Swing • Unique Characteristics:
– In the Linear Mode the Input Common-Mode Voltage Range Includes Ground and the Output Voltage Can Also Swing to Ground, even though Operated from Only a Single Power Supply Voltage.
– The Unity Gain Cross Frequency is Temperature Compensated.
– The Input Bias Current is also Temperature Compensated.
• Advantages:
– Two Internally Compensated Op Amps
– Eliminates Need for Dual Supplies
– Allows Direct Sensing Near GND and VOUT Also Goes to GND
– Compatible with All Forms of Logic
– Power Drain Suitable for Battery Operation

3 Description
The LM158 series consists ...



LM358-N
Product
Folder
Sample &
Buy
Technical
Documents
Tools &
Software
Support &
Community
LM158-N, LM258-N, LM2904-N, LM358-N
SNOSBT3I – JANUARY 2000 – REVISED DECEMBER 2014
LMx58-N Low-Power, Dual-Operational Amplifiers
1 Features
1 Available in 8-Bump DSBGA Chip-Sized Package,
(See AN-1112, SNVA009)
• Internally Frequency Compensated for Unity Gain
• Large DC Voltage Gain: 100 dB
• Wide Bandwidth (Unity Gain): 1 MHz
(Temperature Compensated)
• Wide Power Supply Range:
– Single Supply: 3V to 32V
– Or Dual Supplies: ±1.5V to ±16V
• Very Low Supply Current Drain (500
μA)—Essentially Independent of Supply Voltage
• Low Input Offset Voltage: 2 mV
• Input Common-Mode Voltage Range Includes
Ground
• Differential Input Voltage Range Equal to the
Power Supply Voltage
• Large Output Voltage Swing
• Unique Characteristics:
– In the Linear Mode the Input Common-Mode
Voltage Range Includes Ground and the
Output Voltage Can Also Swing to Ground,
even though Operated from Only a Single
Power Supply Voltage.
– The Unity Gain Cross Frequency is
Temperature Compensated.
– The Input Bias Current is also Temperature
Compensated.
• Advantages:
– Two Internally Compensated Op Amps
– Eliminates Need for Dual Supplies
– Allows Direct Sensing Near GND and VOUT
Also Goes to GND
– Compatible with All Forms of Logic
– Power Drain Suitable for Battery Operation
3 Description
The LM158 series consists of two independent, high
gain, internally frequency compensated operational
amplifiers which were designed specifically to operate
from a single power supply over a wide range of
voltages. Operation from split power supplies is also
possible and the low power supply current drain is
independent of the magnitude of the power supply
voltage.
Application areas include transducer amplifiers, dc
gain blocks and all the conventional op-amp circuits
which now can be more easily implemented in single
power supply systems. For example, the LM158
series can be directly operated off of the standard
3.3-V power supply voltage which is used in digital
systems and will easily provide the required interface
electronics without requiring the additional ±15V
power supplies.
The LM358 and LM2904 are available in a chip sized
package (8-Bump DSBGA) using TI's DSBGA
package technology.
Device Information(1)
PART NUMBER PACKAGE BODY SIZE (NOM)
LM158-N
TO-CAN (8)
CDIP (8)
9.08 mm x 9.09 mm
10.16 mm x 6.502 mm
LM258-N
TO-CAN (8) 9.08 mm x 9.09 mm
DSBGA (8) 1.31 mm x 1.31 mm
LM2904-N
SOIC (8)
4.90 mm x 3.91 mm
PDIP (8)
9.81 mm x 6.35 mm
TO-CAN (8) 9.08 mm x 9.09 mm
LM358-N
DSBGA (8)
SOIC (8)
1.31 mm x 1.31 mm
4.90 mm x 3.91 mm
PDIP (8)
9.81 mm x 6.35 mm
(1) For all available packages, see the orderable addendum at
the end of the datasheet.
Voltage Controlled Oscillator (VCO)
2 Applications
• Active Filters
• General Signal Conditioning and Amplification
• 4- to 20-mA Current Loop Transmitters
1
An IMPORTANT NOTICE at the end of this data sheet addresses availability, warranty, changes, use in safety-critical applications,
intellectual property matters and other important disclaimers. PRODUCTION DATA.

LM358-N
LM158-N, LM258-N, LM2904-N, LM358-N
SNOSBT3I – JANUARY 2000 – REVISED DECEMBER 2014
www.ti.com
Table of Contents
1 Features .................................................................. 1
2 Applications ........................................................... 1
3 Description ............................................................. 1
4 Revision History..................................................... 2
5 Pin Configuration and Functions ......................... 3
6 Specifications......................................................... 4
6.1 Absolute Maximum Ratings ...................................... 4
6.2 ESD Ratings ............................................................ 4
6.3 Recommended Operating Conditions....................... 5
6.4 Thermal Information .................................................. 5
6.5 Electrical Characteristics: LM158A, LM358A, LM158,
LM258 ........................................................................ 5
6.6 Electrical Characteristics: LM358, LM2904............... 7
6.7 Typical Characteristics .............................................. 9
7 Detailed Description ............................................ 12
7.1 Overview ................................................................. 12
7.2 Functional Block Diagram ....................................... 12
7.3 Feature Description................................................. 12
7.4 Device Functional Modes........................................ 13
8 Application and Implementation ........................ 14
8.1 Application Information............................................ 14
8.2 Typical Applications ................................................ 14
9 Power Supply Recommendations...................... 24
10 Layout................................................................... 24
10.1 Layout Guidelines ................................................. 24
10.2 Layout Example .................................................... 24
11 Device and Documentation Support ................. 25
11.1 Related Links ........................................................ 25
11.2 Trademarks ........................................................... 25
11.3 Electrostatic Discharge Caution ............................ 25
11.4 Glossary ................................................................ 25
12 Mechanical, Packaging, and Orderable
Information ........................................................... 25
4 Revision History
NOTE: Page numbers for previous revisions may differ from page numbers in the current version.
Changes from Revision H (March 2013) to Revision I
Page
• Added Pin Configuration and Functions section, ESD Ratings table, Feature Description section, Device Functional
Modes, Application and Implementation section, Power Supply Recommendations section, Layout section, Device
and Documentation Support section, and Mechanical, Packaging, and Orderable Information section .............................. 1
Changes from Revision G (March 2013) to Revision H
Page
• Changed layout of National Data Sheet to TI format ........................................................................................................... 25
2 Submit Documentation Feedback
Copyright © 2000–2014, Texas Instruments Incorporated
Product Folder Links: LM158-N LM258-N LM2904-N LM358-N




@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)