Line Interface. PEB4364 Datasheet
Preliminary Data Sheet, DS3, July 2003
Dual Channel Subscriber Line
PEB 3264, Version 1.4
PEB 3265, Version 1.5
PEB 4264/-2, Version 1.1/1.2
PEB 4364, Version 1.1/1.2
PEB 4265/-2, Version 1.1/1.2
PEB 4365, Version 1.2
PEB 4266, Version 1.2
Never stop thinking.
ABM®, ACE®, AOP®, ARCOFI®, ASM®, ASP®, DigiTape®, DuSLIC®, EPIC®, ELIC®,
FALC®, GEMINAX®, IDEC®, INCA®, IOM®, IPAT®-2, ISAC®, ITAC®, IWE®, IWORX®,
MUSAC®, MuSLIC®, OCTAT®, OptiPort®, POTSWIRE®, QUAT®, QuadFALC®,
SCOUT®, SICAT®, SICOFI®, SIDEC®, SLICOFI®, SMINT®, SOCRATES®, VINETIC®,
10BaseV®, 10BaseVX® are registered trademarks of Infineon Technologies AG.
10BaseS™, EasyPort™, VDSLite™ are trademarks of Infineon Technologies AG.
Microsoft® is a registered trademark of Microsoft Corporation. Linux® is a registered
trademark of Linus Torvalds.
The information in this document is subject to change without notice.
Published by Infineon Technologies AG,
81669 München, Germany
© Infineon Technologies AG 2003.
All Rights Reserved.
The information herein is given to describe certain components and shall not be considered as warranted
Terms of delivery and rights to technical change reserved.
We hereby disclaim any and all warranties, including but not limited to warranties of non-infringement, regarding
circuits, descriptions and charts stated herein.
Infineon Technologies is an approved CECC manufacturer.
For further information on technology, delivery terms and conditions and prices please contact your nearest
Infineon Technologies Office in Germany or our Infineon Technologies Representatives worldwide
Due to technical requirements components may contain dangerous substances. For information on the types in
question please contact your nearest Infineon Technologies Office.
Infineon Technologies Components may only be used in life-support devices or systems with the express written
approval of Infineon Technologies, if a failure of such components can reasonably be expected to cause the failure
of that life-support device or system, or to affect the safety or effectiveness of that device or system. Life support
devices or systems are intended to be implanted in the human body, or to support and/or maintain and sustain
and/or protect human life. If they fail, it is reasonable to assume that the health of the user or other persons may
Preliminary Data Sheet
Previous Version: DS2
Subjects (major changes since last revision)
Product name corrected to Dual Channel Subscriber Line Interface
PEB 3265 version changed from 1.2 to 1.5
PEB 4264/-2 and PEB 4265/-2: version 1.2 added
PEB 4266 version changed from 1.1 to 1.2
PEB 3264 version changed from 1.2 to 1.4
Bit VRTLIM renamed to VTRLIM
Bit VRTLIM-M renamed to VTRLIM-M
New SLICs TSLIC-E and TSLIC-S added
New SLICOFI-2 (Version 1.5 only) package P-TQFP-64-1 added
New package P-VQFN-48-4 for SLIC-S/-S2, SLIC-E/-E2 and SLIC-P
Former chapter 2 "Pin Descriptions" removed. See updated device data
Page 18 “Overview” on Page 18: Chapter reworked, tables for codec and SLIC
Page 23 “Features” on Page 23: ITU-T Recommendation G.712 added
Page 25 “Logic Symbols” on Page 25: Logic symbol for SLIC-E/-E2 Version 1.2
Page 32 “Block Diagram SLICOFI-2/-2S” on Page 32: block diagrams of SLIC
Figure 10 "Signal Paths – DC Feeding" on Page 33: CITA (CITB) renamed
to CITACA (CITACB).
Table 4 "DC Characteristics" on Page 38: VLIM changed from 50 V to 72
Figure 19 "Signal Paths – AC Transmission" on Page 42: CITA (CITB)
renamed to CITACA (CITACB).
“Internal Balanced Ringing via SLICs” on Page 50:
VDROP,RT renamed to VDROP,TR, VRT,RMS renamed to VTR,RMS, VRT0,RMS
renamed to VTR0,RMS
Figure 30 "Bellcore On-Hook Caller ID Physical Layer Transmission"
on Page 61: note added.
Page 61 “Caller ID Buffer Handling of SLICOFI-2” on Page 61: description for
listing item (9) changed
Page 64 “Non Linear Processor (NLP) in DuSLIC-E/-E2/-P” on Page 64 added.