CRD44800-ST-FB Datasheet: 60 W Full-Bridge Reference Design





CRD44800-ST-FB 60 W Full-Bridge Reference Design Datasheet

Part Number CRD44800-ST-FB
Description 60 W Full-Bridge Reference Design
Manufacture Cirrus Logic
Total Page 28 Pages
PDF Download Download CRD44800-ST-FB Datasheet PDF

Features: www.DataSheet4U.com CRD44800-ST-FB 60 W Full-Bridge Reference Design for the CS44800 Features Eight full-bridge chan nels, 60 W each Programmable load compe nsation Power Supply Rejection (PSR) fe edback allowing amplifier to operate fr om low cost linear unregulated power su pplies Peak signal limiting Thermal and over-current protection > 85% amplifie r efficiency Works with GUI to configur e the board or in a standalone mode for easy operation. Demonstrates recommend ed layout and grounding arrangements 10 % THD+N). A 155 W Switched Mode Power S upply (SMPS) is used to power the CRD44 800-ST-FB. As shown below, the CS44800 IC takes four stereo digital audio inpu ts in I²S format and converts them to PWM outputs. This 64-pin LQFP IC provid es an integrated sample rate converter for 32 kHz-192 kHz input sample rate su pport, volume up/down, speaker load com pensation, peak limiting to prevent amp lifier clipping, power supply ripple co mpensation, and AM frequency interference elimination. This refe.

Keywords: CRD44800-ST-FB, datasheet, pdf, Cirrus Logic, 60, W, Full-Bridge, Reference, Design, stock, pinout, distributor, price, schematic, inventory, databook, Electronic, Components, Parameters, parts, cross reference, chip, Semiconductor, circuit, Electric, manual, substitute, Equivalent

www.DataSheet4U.com
CRD44800-ST-FB
60 W Full-Bridge Reference Design for the CS44800
Features
Eight full-bridge channels, 60 W each
Programmable load compensation
Power Supply Rejection (PSR) feedback
allowing amplifier to operate from low cost
linear unregulated power supplies
Peak signal limiting
Thermal and over-current protection
> 85% amplifier efficiency
Works with GUI to configure the board or in a
standalone mode for easy operation.
Demonstrates recommended layout and
grounding arrangements
Description
The CRD44800-ST-FB PWM Amplifier demonstrates
the CS44800, Cirrus’ eight-channel pure digital PMW
controller. This reference design implements an eight-
channel amplifier which delivers 60 W per full-bridge
channel into 8 loads using a single +30 V supply (at
I
10% THD+N). A 155 W Switched Mode Power Supply
(SMPS) is used to power the CRD44800-ST-FB.
As shown below, the CS44800 IC takes four stereo dig-
ital audio inputs in I²S format and converts them to PWM
outputs. This 64-pin LQFP IC provides an integrated
sample rate converter for 32 kHz-192 kHz input sample
rate support, volume up/down, speaker load compensa-
tion, peak limiting to prevent amplifier clipping, power
supply ripple compensation, and AM frequency interfer-
ence elimination.
This reference design uses the the ST Micro STA500, an
integrated power stage back end for digital amplifiers
(four STA500 parts configured as full-bridges are used
for this eight-channel design). Current limiting and ther-
mal protection are provided by the STA500.
The inductor/capacitor 2nd order low pass filter (LPF) re-
moves high frequency components from the output
signal effectively converting it from digital to analog.
ORDERING INFORMATION
CRD44800-ST-FB
Reference Design
155W Switched Mode
Power Supply
+30V/+5V
PSR Circuitry
+30V
CS4461 ADC
Audio Driver Board
I2S Clocks & Data
I2C Host Control
CS44800
(PWM Controller)
PWM Outputs
To channels 3/4
To channels 5/6
To channels 7/8
+30V
ST Micro
STA500A
LPF
LPF
Channels 1 and 2 (of 8)
8
8
Cirrus Logic, Inc.
www.cirrus.com
©Copyright Cirrus Logic, Inc. 2004
(All Rights Reserved)
DEC ‘04
DS632ARD1
1

                    
                    






Index : 0  1  2  3   4  5  6  7   8  9  A  B   C  D  E  F   G  H  I  J   K  L  M  N   O  P  Q  R   S  T  U  V   W  X  Y  Z
@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site (Privacy Policy & Contact)