Sink Compound. NTE303A Datasheet
MATERIAL SAFETY DATA SHEET
Silicone Heat Sink Compound
Date-Issued: Aug, 2005
MSDS Ref. No: NTE303A
Revision No: New MSDS
I. PRODUCT AND SUPPLIER INFORMATION
PRODUCT NAME: NTE303A
Product Synonyms: Silicone Thermal Compound
Chemical family or Formula: Complex Mixture
NTE Electronics, Inc.
44 Farrand Street
Bloomfield, NJ 07003
MSDS number: NTE303A
Note: The purpose of this MSDS is to provide safe handling, shipping and disposal information for users of
the product. It is not intended to, nor does it, provide complete or extensive toxicological data on the
product or its components. Users who require this information are referred to primary suppliers of the
ingredients of interest.
II. COMPOSITION AND INFORMATION ON INGREDIENTS
* Material in non-airborn form
III. HAZARDS IDENTIFICATION
OSHA Hazard Classification:
No warning statements required.
Routes of Entry:
Inhalation, skin contact, ingestion
Avoid contact with all oxidizing agents
IV FIRST AID
Remove individual to fresh air. If not breathing, give artificial respiration or oxygen as appropriate.
Keep patient warm. Seek immediate medical advice.
Not an expected route of entry. Overexposure may cause irritation of the mucous membranes and
Flush skin thoroughly with soap and water. Rinse thoroughly. Seek medical advice if contact was
extensive. Prolonged direct skin contact may cause dermatitis or irritation.
Immediately flush eyes with plenty of water while holding eyelids apart. Seek immediate medical
Overexposure to direct eye contact may cause redness, irritation, discomfort or tearing.
May produce laxative effect.
Seek immediate medical advice. Never give anything by mouth to an unconscious person.
Not an expected route of exposure. Ingestion may cause abdominal pains, cramping, nausea or
Notes To Physician: Treat symptomatically.
V. FIRE FIGHTING MEASURES
Flash Point: > 400 F
This material is not considered a potential fire and explosion hazard under normal operating conditions.
Foam, dry chemical, CO2. Water spray may be used to cool containers.
Do not allow, contaminated water to enter sewers or waterways.
Fire Fighting Instructions:
In case of fire, use normal fire fighting equipment including a NIOSH approved self-contained breathing
apparatus (SCBA). Use water to cool containers.
Hazardous Combustion Products:
Oxides of carbon.
1. ACCIDENTAL RELEASE MEASURES
Personal Protection for Emergency Situations:
Evacuate the area of all unnecessary personnel. Eliminate any ignition sources until the area is
determined to be free from explosion and fire hazards. Contain the release and eliminate its source if
this can be done safely.
Wear protective clothing. Keep unprotected persons away from spill.
Spill Mitigation Procedures
Low volatility makes this hazard unlikely.
Provide adequate ventilation. Keep away from ignition sources
Contain all liquid for treatment and/or disposal as a (potential) hazardous waste.
Notify all downstream users of possible contamination. Keep away from ignition sources.
Do not flush to sewer! US regulations (CERCLA) require reporting spills and releases to soil, water and
air in excess of stipulated quantities. US Coast Guard National Response Center is 800-424-8802.