6.4 Internal Register Description
There is a total of 16 registers each containing several parameters. For a detailed description of the
parameters refer the Register summary.
The serial register has read (1) / write (0) function. D [15:12] are the register address, D  defined the
read or write mode and D [10:0] are the data. Register 14 is a read only register and is used for chip
identification. At power-on, the default values specified for each parameter (in Register summary)
are taken. All data, except S0 D[3:2], are validated on the negative edge of Vsync. In 3-wire register, GRB
clear registers to default value except GRB value. If less than 16-bit data are read during the CS low time
period the data is cancelled.
Free Datasheet http://www.datasheet4u.com/