DatasheetsPDF.com

TLC59108

Texas Instruments
Part Number TLC59108
Manufacturer Texas Instruments
Description 8-Bit Fm+ I2C-Bus Constant-Current LED Sink Driver
Published Oct 1, 2019
Detailed Description Product Folder Sample & Buy Technical Documents Tools & Software Support & Community TLC59108 SLDS156B – MARCH 2009...
Datasheet PDF File TLC59108 PDF File

TLC59108
TLC59108


Overview
Product Folder Sample & Buy Technical Documents Tools & Software Support & Community TLC59108 SLDS156B – MARCH 2009 – REVISED JULY 2015 TLC59108 8-Bit Fm+ I2C-Bus Constant-Current LED Sink Driver 1 Features • Eight LED Drivers (Each Output Programmable At Off, On, Programmable LED Brightness, Programmable Group Dimming/Blinking Mixed With Individual LED Brightness • Eight Constant-Current Output Channels • 256-Step (8-Bit) Linear Programmable Brightness Per LED Output Varying From Fully Off (Default) to Maximum Brightness Using a 97-kHz PWM Signal • 256-Step Group Brightness Control Allows General Dimming (Using a 190-Hz PWM Signal From Fully Off to Maximum Brightness (Default) • 256-Step Group Blinking With Frequency Programmable From 24 Hz to 10.
73 s and Duty Cycle From 0% to 99.
6% • Four Hardware Address Pins Allow 14 TLC59108 Devices to be Connected to the Same I2C Bus • Four Software-Programmable I2C Bus Addresses (One LED Group Call Address and Three LED Sub Call Addresses) Allow Groups of Devices to be Addressed at the Same Time in Any Combination.
For Example, One Register Used for All Call, so That All the TLC59108 Devices on the I2C Bus Can be Addressed at the Same Time, and the Second Register Can be Used for Three Different Addresses so That One-Third of All Devices on the Bus Can be Addressed at the Same Time in a Group.
• Software Enable and Disable for I2C Bus Address • Software Reset Feature (SWRST Call) Allows Device to be Reset Through I2C Bus • Up to 14 Possible Hardware-Adjustable Individual I2C Bus Addresses Per Device, So That Each Device Can Be Programmed • Open-Load/Overtemperature Detection Mode to Detect Individual LED Errors • Output State Change Programmable on the Acknowledge or the Stop Command to Update Outputs Byte by Byte or All at the Same Time (Default to Change on Stop) • Constant Output Current Adjusted Through an External Resistor (10mA to 120mA) • Maximum Output Voltage: 17 V 1 • 25-MHz Internal Oscillator Requires No E...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)