DatasheetsPDF.com

DS75154

National Semiconductor
Part Number DS75154
Manufacturer National Semiconductor
Description Quad Line Receiver
Published Mar 30, 2005
Detailed Description DS75154 Quad Line Receiver May 1998 DS75154 Quad Line Receiver General Description The DS75154 is a quad monolithic li...
Datasheet PDF File DS75154 PDF File

DS75154
DS75154

Overview
DS75154 Quad Line Receiver May 1998 DS75154 Quad Line Receiver General Description The DS75154 is a quad monolithic line receiver designed to satisfy the requirements of the standard interface between data terminal equipment and data communication equipment as defined by EIA Standard RS-232C.
Other applications are in relatively short, single-line, point-to-point data transmission systems and for level translators.
Operation is normally from a single 5V supply; however, a built-in option allows operation from a 12V supply without the use of additional components.
The output is compatible with most TTL and LS circuits when either supply voltage is used.
In normal operation, the threshold-control terminals are connected to the VCC1 terminal, pin 15, even if power is being supplied via the alternate VCC2 terminal, pin 16.
This provides a wide hysteresis loop which is the difference between the positive-going and negative-going threshold voltages.
In this mode, if the input voltage goes to zero, the output voltage will remain at the low or high level as determined by the previous input.
For fail-safe operation, the threshold-control terminals are open.
This reduces the hysteresis loop by causing the negative-going threshold voltage to be above zero.
The positive-going threshold voltage remains above zero as it is unaffected by the disposition of the threshold terminals.
In the fail-safe mode, if the input voltage goes to zero or an open-circuit condition, the output will go to the high level regardless of the previous input condition.
Features n Input resistance, 3 kΩ to 7 kΩ over full RS-232C voltage range n Input threshold adjustable to meet “fail-safe” requirements without using external components n Inverting output compatible with TTL or LS n Built-in hysteresis for increased noise immunity n Output with active pull-up for symmetrical switching speeds n Standard supply voltage — 5V or 12V Schematic Diagram DS005795-1 Note: When using VCC1 (pin 15), VCC2 (pin ...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)