DatasheetsPDF.com

LTC1164-7

Part Number LTC1164-7
Manufacturer Linear Technology
Title Low Power/ Linear Phase 8th Order Lowpass Filter
Description LTC1164-7 Low Power, Linear Phase 8th Order Lowpass Filter FEATURES s s s s s s s s DESCRIPTIO Better Than Bessel Roll-Off fCUTOFF up to 20kHz, ...
Features s s s s s s s s DESCRIPTIO Better Than Bessel Roll-Off fCUTOFF up to 20kHz, Single 5V Supply ISUPPLY = 2.5mA (Typ), Single 5V Supply 75dB THD + Noise with Single 5V Supply Phase and Group Delay Response Fully Tested Transient Response with No Ringing Wide Dynamic Range No External Components Neede...

File Size 300.98KB
Datasheet LTC1164-7 PDF File







Similar Datasheet

LTC1164-5 : LTC1164-5 Low Power 8th Order Pin Selectable Butterworth or Bessel Lowpass Filter DESCRIPTIO The LTC®1164-5 is a monolithic 8th order filter; it approximates either a Butterworth or a Bessel lowpass response. The LTC1164-5 features clock-tunable cutoff frequency and low power consumption (4.5mA with ± 5V supplies and 2.5mA with single 5V supply). Low power operation is achieved without compromising noise or distortion performance. With ± 5V supplies and 10kHz cutoff frequency, the operating signal-to-noise ratio is 86dB and the THD throughout the passband is 0.015%. Under the same conditions, a 77dB signal-tonoise ratio and distortion is obtained with a single 5V supply while the clock feedt.

LTC1164-6 : LTC1164-6 Low Power 8th Order Pin Selectable Elliptic or Linear Phase Lowpass Filter FEATURES s s s s s s DESCRIPTIO s s s 8th Order Pin Selectable Elliptic or Bessel Filter in a 14-Pin Package 4mA Supply Current with ± 5V Supplies 64dB Attenuation at 1.44 fCUTOFF (Elliptic Response) fCUTOFF up to 30kHz (50:1 fCLK to fCUTOFF Ratio) 110µVRMS Wideband Noise with ± 5V Supplies Operates at Single 5V Supply with 1VRMS Input Range Operates up to ± 8V Supplies TTL/CMOS Compatible Clock Input No External Components The LTC1164-6 is a monolithic 8th order elliptic lowpass filter featuring clock-tunable cutoff frequency and low power supply current. Low power operation is achieved without comprom.

LTC1164-8 : The LTC®1164-8 is a monolithic ultraselective, 8th order, elliptic bandpass filter. The passband of the LTC1164-8 is tuned with an external clock and the clock-to-center frequency ratio is 100:1. The – 3dB pass bandwidth is typically 1% of the filter center frequency. The stopband attenuation of the LTC1164-8 is greater than 50dB. The lower and upper stopband frequencies are less than 0.96 • center frequency and greater than 1.04 • center frequency, respectively. The LTC1164-8 requires an external op amp and two external resistors (see the circuit below). The filter’s gain at center frequency is set by the ratio RIN /RF. For a gain equal to one and an optimum dynamic range, RF should be set .




Since 2006. D4U Semicon,
Electronic Components Datasheet Search Site. (Privacy Policy & Contact)