DatasheetsPDF.com

SP8107

Sipex
Part Number SP8107
Manufacturer Sipex
Description Three Channel High Performance Laser Driver
Published Jun 7, 2005
Detailed Description Advanced SP8107 Three Channel High Performance Laser Driver FEATURES • • • • • • • • • Three current controlled inputs...
Datasheet PDF File SP8107 PDF File

SP8107
SP8107

Overview
Advanced SP8107 Three Channel High Performance Laser Driver FEATURES • • • • • • • • • Three current controlled inputs with independent ENABLE/DISABLE Two selectable outputs for grounded laser diodes Output current up to 400mA (250mA per input channel) Independent swing for each output channel controlled by external resistor On-chip oscillator with resistor controlled frequency Single 5V power supply Common ENABLE and oscillator ENABLE inputs TTL/CMOS logic level control signals Small SSOP16 package IR I2 I3 RF EN2 EN3 ENABLE OSCEN 1 2 3 4 5 6 7 8 SP8107 SSOP-16 16 15 14 13 12 11 10 9 Vcc Iout A GND RSA RSB Iout B SELA Vcc APPLICATION • • • DVD-RAM with CD-RW capability DVD-RW with CD-RW capability Writable data storage optical devices GENERAL DESCRIPTION The SP8107 is a three channel laser diode driver specifically designed for high speed DVD-RW or DVDRAM applications.
It operates two grounded laser diodes (650nm for DVD and 780nm for CD) and features three input channels that allow setting of three different optical power levels.
The first channel (IR) has lower gain (100mA/mA) and output current (up to 200mA) and is used as a read channel.
The second (I2) and third (I3) channels have higher gain (250mA/mA) and output current (up to 250mA) and are used as write channels.
Each write channel may be switched on/off at very fast switching speeds with TTL/CMOS logic level signals applied to EN2 and EN3 inputs - channels are enabled at low logic level and disabled at high logic level.
Outputs of all channels are summed together and connected to one of the outputs IOUT A or IOUT B depending on logic signal at the input SELA.
High logic level at SELA selects output IOUT A, while low logic level selects output IOUT B.
Inputs IR, I2, and I3 are current-controlled with 200 ohm DC impedance but allow voltage control by using external limiting resistors.
An on-chip oscillator is used to reduce laser mode hopping in read mode.
The frequency of this oscillator may be cha...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)