DatasheetsPDF.com

DEH-1100

Pioneer
Part Number DEH-1100
Manufacturer Pioneer
Description (DEH-xxxx) Manual
Published May 29, 2006
Detailed Description www.DataSheet4U.com Connecting the Units Note: • This unit is for vehicles with a 12-volt battery and negative groundin...
Datasheet PDF File DEH-1100 PDF File

DEH-1100
DEH-1100

Overview
www.
DataSheet4U.
com Connecting the Units Note: • This unit is for vehicles with a 12-volt battery and negative grounding.
Before installing it in a recreational vehicle, truck, or bus, check the battery voltage.
To avoid shorts in the electrical system, be sure to disconnect the ≠ battery cable before beginning installation.
Refer to the owner’s manual for details on connecting the power amp and other units, then make connections correctly.
Secure the wiring with cable clamps or adhesive tape.
To protect the wiring, wrap adhesive tape around them where they lie against metal parts.
Route and secure all wiring so it cannot touch any moving parts, such as the gear shift, handbrake and seat rails.
Do not route wiring in places that get hot, such as near the heater outlet.
If the insulation of the wiring melts or gets torn, there is a danger of the wiring short-circuiting to the vehicle body.
Don’t pass the yellow lead through a hole into the engine compartment to connect to the battery.
This will damage the lead insulation and cause a very dangerous short.
Do not shorten any leads.
If you do, the protection circuit may fail to work when it should.
Never feed power to other equipment by cutting the insulation of the power supply lead of the unit and tapping into the lead.
The current capacity of the lead will be exceeded, causing overheating.
When replacing fuse, be sure to use only fuse of the rating prescribed on this unit.
Since a unique BPTL circuit is employed, never wire so the speaker leads are directly grounded or the left and right ≠ speaker leads are common.
Speakers connected to this unit must be highpower types with minimum rating of 40 W (45 W)* and impedance of 4 to 8 ohms.
Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke, or becoming damaged.
* DEH-2100 and DEH-21 • When this product’s source is switched ON, a control signal is output through the blue/white lead.
...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)