DatasheetsPDF.com

RA1133J

PerkinElmer Optoelectronics
Part Number RA1133J
Manufacturer PerkinElmer Optoelectronics
Description FULL FRAME CCD IMAGE SENSOR
Published Jul 11, 2007
Detailed Description D A T A S H E E T Imaging Imaging Product Line RA1133J Full Frame CCD Image Sensor 24 µm square pitch, 1100 x 330 pix...
Datasheet PDF File RA1133J PDF File

RA1133J
RA1133J

Overview
D A T A S H E E T Imaging Imaging Product Line RA1133J Full Frame CCD Image Sensor 24 µm square pitch, 1100 x 330 pixel configuration www.
DataSheet4U.
com Description The RA1133J is a full frame CCD sensor with reset capabilities designed specifically for use in spectroscopy, biomedical imaging and related scientific imaging applications.
The package for the array is designed with an integrated two stage thermoelectric cooler.
This enables the device to be run 40° C below ambient temperature, -15° C when compared to room temperature.
Its combination of very low noise and low dark current make it ideal for low light, high dynamic range and high resolution applications.
MPP Operation A major source of dark current in devices such as this originates in surface states at the Si-SiO2 interface.
A unigue design and process enables the RA1133J to be run in "multi-pinned phase" or MPP mode of operation.
This helps eliminate dark current generation in the interface surface states.
By holding the vertical clocks at negative potential during integration and horizontal signal readout, the surface will not be depleted and the surface state will not generate dark current.
Features • 363,000 picture elements (pixels) in a 1100 x 330 configuration • 24 µm square pixels • 2-phase buried channel process • On-chip amplifier for low noise and high speed readout • Dynamic range greater than 25,000:1 • On-chip temperature sensor • Two stage TE cooler integrated into the package • Hermetically sealed • 100% fill factor • 10 MHz data rate The imager is structured with a single output register at one end of the imaging columns.
A lateral reset drain is located adjacent to this readout register which enables the dumping of accumulated charge from the array.
Two phase clocks are needed to drive the readout register.
Three phase clocks are needed to drive imaging cells.
The array is available in a 30-pin metal package with an integrated TE cooler as shown in Figure 1.
Package dimensions...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)