DatasheetsPDF.com

SW90-0004A

Tyco Electronics
Part Number SW90-0004A
Manufacturer Tyco Electronics
Description GaAs SP6T Switch
Published Jul 30, 2007
Detailed Description www.DataSheet4U.com GaAs SP6T Switch, Absorptive, Single Supply DC - 4.0 GHz Features • • • • • • • Operates DC - 4 GHz...
Datasheet PDF File SW90-0004A PDF File

SW90-0004A
SW90-0004A


Overview
www.
DataSheet4U.
com GaAs SP6T Switch, Absorptive, Single Supply DC - 4.
0 GHz Features • • • • • • • Operates DC - 4 GHz on Single Supply ASIC TTL / CMOS Driver Leadless 4 x 7 mm Chip Scale Plastic Package Low DC Power Consumption 50 Ohm Nominal Impedance Test Boards are Available Tape and Reel are Available SW90-0004A V7 Functional Schematic Description M/A-COM's SW90-0004A is a SP6T absorptive pHEMT switch with integral TTL driver.
This device is in an MLP plastic surface mount package.
This switch offers excellent broadband performance and repeatability from DC to 4 GHz, while maintaining low DC power dissipation.
The SW90-0004A is ideally suited for wireless infrastructure applications.
Pin Configuration 4,5,6 Pin No.
1 2 Function CP2 VEE NC C6 C5 C4 C3 C2 C1 NC GND NC GND RF1 GND RF2 GND RF3 Pin No.
19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 Function GND NC GND RFC GND GND RF4 GND RF5 GND RF6 GND NC VEE Vcc NC Vcc CP1 Ordering Information Part Number SW90-0004A SW90-0004ATR SW90-0004A-TB Package Bulk Packaging 1000 piece reel Units Mounted on Test Board 3 4 5 6 7 8 Note: Reference Application Note M513 for reel size information.
9 10 Absolute Maximum Ratings 1,2 Parameter Max.
Input Power 0.
05 GHz 0.
5 - 4.
0 GHz Bias Voltages VCC Control Voltage 3 Operating Temperature Storage Temperature 1.
2.
3.
11 12 13 14 Absolute Maximum +27 dBm +34 dBm +5.
5V -0.
5V to VCC +0.
5V -40°C to +85°C -65°C to +125°C 15 16 17 18 Operation of this device above any one of these parameters may cause permanent damage.
When the RF input is applied to the terminated port, the absolute maximum power is +30 dBm.
Standard CMOS TTL interface, latch-up will occur if logic signal is applied prior to power supply.
4.
NC = No Connection 5.
For single supply operation VEE is internally generated and must remain isolated from external power supplies.
Generated noise is typical of switching DC-DC Converters.
6.
Connections and external components shown in functional schem...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)