DatasheetsPDF.com

APC78106

Bel Fuse
Part Number APC78106
Manufacturer Bel Fuse
Description ADSL CPE Hybrid
Published Nov 14, 2008
Detailed Description ADSL CPE Hybrid APC78106 OPERATING TEMPERATURE -40°C TO +85°C FEATURES APC78106 is designed to interface with Alcatel’s...
Datasheet PDF File APC78106 PDF File

APC78106
APC78106

Overview
ADSL CPE Hybrid APC78106 OPERATING TEMPERATURE -40°C TO +85°C FEATURES APC78106 is designed to interface with Alcatel’s MTK20150 and MTK20141 ADSL transceiver chip sets to optimize customer premises equipment (CPE) designs.
The Hybrid contains every component required between the analog front end chip and the connector including the line interface transformer and common mode chokes, line protection circuitry, transmit and receive filters www.
DataSheet4U.
com (excluding line driver and parallel capacitors).
• The hybrid was designed jointly by APC and Alcatel to optimize the transmission capabilities of the “Dynamite” chip set.
It meets or exceeds the requirements of the standards as specified in TS101 388, T1.
413 and ETR328.
It also provides BS EN60950 / IEC60950 / TS 001 / AS/NZS 3260 / CAN/ CSA C22.
2 Np.
950-95 / UL1950 and CB Certificate supplementary insulation and UL Component Recognition (File No.
E175058).
• SCHEMATIC Pin (1-2) Pin (3-16) Pin 1 Pin 2 Pin 3 Pin 4 Pin 5 Pin 6 Pin 7 Pin 8 NOTES: TNV SELV Tip Ring Txp Txn A_Gnd_Tx N/C Hybrid Gnd Plane Rxp Pin 9 Pin 10 Pin 11 Pin 12 Pin 13 Pin 14 Pin 15 Pin 16 Pin 17 Pin 18 Rxn 8016 pin 4 / EL1510CS pin 3 8016 pin 2 / EL1510CS pin 1 8016 pin 3 / EL1510CS pin 2 N/C 8016 pin 21 / EL1510CS pin 5 8016 pin 23 / EL1510CS pin 7 8016 pin 22 / EL1510CS pin 6 N/C N/C ADI 8016 LINE DRIVER = 24 LEAD BATWING ELANTEC EL1510CS LINE DRIVER = 8 PIN SO 1.
ALL TRACES BETWEEN APC PINS 10 AND 14 AND ADI LINE DRIVER PINS 4 AND 21 RESPECTIVELY, MUST BE KEPT SYMMETRICAL, PARALLEL AND EQUIDISTANT.
2.
TWO 4.
7NF PARALLEL CAPACITORS SHOULD BE PLACED BETWEEN ADI LINE DRIVER PIN 4 AND AGT (A_GND_TX) AND BETWEEN ADI LINE DRIVER PIN 21 AND AGT (A_GND_TX).
THESE NEED TO BE PLACED AS CLOSE TO THE ADI LINE DRIVER AS POSSIBLE.
SAFETY NOTE: THE CIRCUIT ON THE LC SIDE OF THE TRANSFORMER IS A SELV CIRCUIT AND THE CIRCUIT ON THE LINE SIDE OF THE TRANSFORMER IS A TNV CIRCUIT.
- CIRCUITRY DESIGNATED AS SELV SHALL ONLY BE CONNECTED TO OTHER SELV CIRCUI...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)