DatasheetsPDF.com

MAX7031

Maxim Integrated Products
Part Number MAX7031
Manufacturer Maxim Integrated Products
Description ASK Transceiver
Published Jun 10, 2009
Detailed Description 19-3707; Rev 0; 5/05 Low-Cost, 308MHz, 315MHz, and 433.92MHz FSK Transceiver with Fractional-N PLL General Description ...
Datasheet PDF File MAX7031 PDF File

MAX7031
MAX7031

Overview
19-3707; Rev 0; 5/05 Low-Cost, 308MHz, 315MHz, and 433.
92MHz FSK Transceiver with Fractional-N PLL General Description www.
datasheet4u.
com Features ♦ +2.
1V to +3.
6V or +4.
5V to +5.
5V Single-Supply Operation ♦ Single-Crystal Transceiver ♦ Factory-Preset Frequency (No Serial Interface Required) ♦ FSK Modulation ♦ Factory-Preset FSK Frequency Deviation ♦ +10dBm Output Power into 50Ω Load ♦ Integrated TX/RX Switch ♦ Integrated Transmit and Receive PLL, VCO, and Loop Filter ♦ > 45dB Image Rejection ♦ Typical RF Sensitivity*: -110dBm ♦ Selectable IF Bandwidth with External Filter ♦ RSSI Output with High Dynamic Range ♦ < 12.
5mA Transmit-Mode Current ♦ < 6.
7mA Receive-Mode Current ♦ < 800nA Shutdown Current ♦ Fast-On Startup Feature, < 250µs ♦ Small, 32-Pin, Thin QFN Package *0.
2% BER, 4kbps Manchester-encoded data, 280kHz IF BW MAX7031 The MAX7031 crystal-based, fractional-N transceiver is designed to transmit and receive FSK data at factorypreset carrier frequencies of 308MHz †, 315MHz, or 433.
92MHz with data rates up to 33kbps (Manchester encoded) or 66kbps (NRZ encoded).
This device generates a typical output power of +10dBm into a 50 Ω load, and exhibits typical sensitivity of -110dBm.
The MAX7031 features separate transmit and receive pins (PAOUT and LNAIN) and provides an internal RF switch that can be used to connect the transmit and receive pins to a common antenna.
The MAX7031 transmit frequency is generated by a 16bit, fractional-N, phase-locked loop (PLL), while the receiver’s local oscillator (LO) is generated by an integer-N PLL.
This hybrid architecture eliminates the need for separate transmit and receive crystal reference oscillators because the fractional-N PLL is preset to be 10.
7MHz above the receive LO.
Retaining the fixed-N PLL for the receiver avoids the higher current-drain requirements of a fractional-N PLL and keeps the receiver current drain as low as possible.
The fractional-N architecture of the MAX7031 transmit PLL allows the transmit FSK ...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)