DatasheetsPDF.com

F980J476MSA

Nichicon corporation
Part Number F980J476MSA
Manufacturer Nichicon corporation
Description SOLID TANTALUM ELECTROLYTIC CAPACITORS
Published Jan 26, 2010
Detailed Description SOLID TANTALUM ELECTROLYTIC CAPACITORS F98 Resin-molded Chip, High Capacitance Series Adapted to the RoHS directive (...
Datasheet PDF File F980J476MSA PDF File

F980J476MSA
F980J476MSA

Overview
SOLID TANTALUM ELECTROLYTIC CAPACITORS F98 Resin-molded Chip, High Capacitance Series Adapted to the RoHS directive (2002/95/EC).
Specifications Item Category Temperature Range Capacitance Tolerance Performance Characteristics -55 ~ +125°C (Rated temperature : 85°C) ± 20% (at 120Hz) Refer to the list below (* 1) After 5 minute's application of rated voltage, leakage current at 20°C is not more than 0.
1CV or 0.
5µA, whichever is greater.
At 40°C, 90 ~ 95% R.
H.
, For 500hours (No voltage applied) Capacitance Change Refor to the list below (* 1) Dissipation Factor 150% or less of initial specified value Leakage Current 200% or less of initial specified value At -55°C / +125°C, For 30 minutes each, 5 cycles Capacitance Change Refor to the list below (* 1) Dissipation Factor 150% or less of initial specified value Leakage Current Initial specified value or less At 260°C, For 10 seconds, Reflow, Capacitance Change Refor to the list below (* 1) Leakage Current Initial specified value or less Leakage Current Initial specified value or less After application of surge in series with a 1kΩ resistor at the rate of 30 seconds ON, 30 seconds OFF, for 1000 successive test cycles at 85°C, capacitors meet the characteristics requirements listed below.
Refor to the list below (* 1) Capacitance Change Dissipation Factor 150% or less of initial specified value Leakage Current 200% or less of initial specified value After 1000 hours' application of rated voltage in series with a 3Ω resistor at 85°C, capacitors meet the characteristic requirements listed below Refor to the list below (* 1) Capacitance Change Dissipation Factor 150% or less of initial specified value Leakage Current 200% or less of initial specified value After applying the pressure load of 5N for 10±1 seconds horizontally to the center of capacitor side body which has no electrode and has been soldered beforehand on an aluminum substrate, there shall be found neither exfoliation nor its sign at the terminal electrode.
...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)