DatasheetsPDF.com

25SVPD39M

Sanyo Semiconductor
Part Number 25SVPD39M
Manufacturer Sanyo Semiconductor
Description SVPD Series Capacitors
Published Mar 2, 2012
Detailed Description www.DataSheet.co.kr 4. SPECIFICATIONS FOR EACH SERIES Conductive polymer type SVPD Series Guaranteed at 125°C, 85°C ...
Datasheet PDF File 25SVPD39M PDF File

25SVPD39M
25SVPD39M

Overview
www.
DataSheet.
co.
kr 4.
SPECIFICATIONS FOR EACH SERIES Conductive polymer type SVPD Series Guaranteed at 125°C, 85°C 85% guaranteed,Rated 35V, Rated 35V max.
The SVQP series guaranteed 125°C This product is very reliable, guaranteeing 85°C 85% performance.
Suitable for use in smoothing circuits of vehiclemounted equipment, industrial equipment, etc.
This product can support lead free-reflow.
( 2).
Specifications Items Category temperature range Tolerance on rated capacitance Tangent of loss angle Leakage current 1 ESR Characteristics of impedance ratio at high temp.
and low temp.
Conditions Marking : Polarity( ), Rated voltage, (Purple) SVPD Rated capacitance, Lot.
No.
Characteristics -55°C to +125°C M : ±20% 120Hz Less than or equal to the value of Table2 120Hz Less than or equal to the value of Table2 After 2 minutes Less than or equal to the value of Table2 Z / Z 20°C 0.
75 to 1.
25 Based the value at -55°C 0.
75 to 1.
25 Z / Z 20°C 100KHz +20°C +125°C Within ±20% ∆C/C 2 times or less than an initial standard 125°C, 2,000h, Rated tanδ Endurance 2 times or less than an initial standard voltage applied ESR Leakage current Below an initial standard Within ±20% ∆C/C 85°C, 85 to 90% RH, 2 times or less than an initial standard tanδ Damp heat (Steady state) 1,000h, 2 times or less than an initial standard ESR Rated voltage applied Leakage current Below an initial standard Within ±10% ∆C/C Resistance to 1.
3 times or less than an initial standard tan δ 2 (VPS) (230°C X 75s) soldering heat 1.
3 times or less than an initial standard ESR Leakage current Below an initial standard (after voltage processing) 1 In case of some problems for measured values, measure after applying rated voltage for 120 minutes at 125°C .
2 Refer to Page 56 for reflow soldering conditions.
Dimensions 0.
2max.
W (unit : mm) Size Code C6 E7 F8 E12 F12 φD±0.
5 6.
3 8.
0 10.
0 8.
0 10.
0 +0.
1 L -0.
4 5.
9 6.
9 7.
9 11.
9 12.
6 W±0.
2 6.
6 8.
3 10.
3 8.
3 10.
3 H±0.
2 6.
6 8.
3 10.
3 8.
3 10.
3 C±0.
2 7.
3 9.
0 11.
0 9.
0 11.
0 R...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)