DatasheetsPDF.com

TLE7209-2R

Infineon
Part Number TLE7209-2R
Manufacturer Infineon
Description 7A H-Bridge
Published Mar 10, 2014
Detailed Description 7 A H-Bridge for DC-Motor Applications TLE 7209-2R Preliminary Datasheet 1 1.1 Overview Features • Operating supply...
Datasheet PDF File TLE7209-2R PDF File

TLE7209-2R
TLE7209-2R


Overview
7 A H-Bridge for DC-Motor Applications TLE 7209-2R Preliminary Datasheet 1 1.
1 Overview Features • Operating supply voltage 5 V to 28 V • Typical RDSon = 150 mΩ for each output transistor (at 25 °C) • Continuous DC load current 3.
5 A (TC < 100 °C) • Output current limitation at typ.
6.
6 A ± 1.
1 A • Short circuit shut-down for output currents over 8 A • Logic- inputs TTL/CMOS-compatible • Output switching frequency up to 30 kHz • Rise and fall times optimized for 0.
5-2 kHz • Over-temperature protection • Short circuit protection • Undervoltage disable function • Diagnostic by SPI or Status-Flag (configurable) • Enable and Disable input • P-DSO-20-12 power package Type TLE 7209-2R Functional Description The TLE 7209-2R is an intelligent full H-Bridge, designed for the control of DC and stepper motors in safety critical applications and under extreme environmental conditions.
The H-Bridge is protected against over-temperature and short circuits and has an under voltage lockout for all the supply voltages “VS” (main DC power supply).
All malfunctions cause the output stages to go tristate.
The device is configurable by the DMS pin.
When grounded, the device gives diagnostic information via a simple error flag.
When supplied with VCC = 5 V, the device works in SPI mode.
In this mode, detailed failure diagnosis is available via the serial interface.
Ordering Code on request Package P-DSO-20-12 Preliminary Datasheet 1 V1.
0, 2004-mar-12 Free Datasheet http://www.
datasheetlist.
com/ TLE 7209-2R Overview 1.
2 Pin Configuration GND S C K /S F IN 1 VS CP VS O UT1 O UT1 SDO SDI GND 1 2 3 4 5 6 7 8 9 10 20 19 18 17 16 15 14 13 12 11 GND IN 2 D IS CSN VS O U T2 O U T2 EN DMS GND M etal slug is connected to G N D pins internally Figure 1 Table 1 Pin.
No.
1 2 3 4 5, 16 6, 7 8 9 10 11 Pinout TLE 7209-2R Pin Definitions and Functions Symbol GND SCK/SF IN1 Function Ground SPI-Clock/Status-flag Input 1 Supply voltage for internal charge pump Supply voltage; connect pin...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)