DatasheetsPDF.com

TA-SB500WR2

Sony
Part Number TA-SB500WR2
Manufacturer Sony
Description SURROUND AMPLIFIER SERVICE MANUAL
Published Jun 11, 2014
Detailed Description TA-SB500WR2 SERVICE MANUAL Ver. 1.0 2007.03 US Model • TA-SB500WR2 is the surround amplifier section in DAV-HDX267W/HD...
Datasheet PDF File TA-SB500WR2 PDF File

TA-SB500WR2
TA-SB500WR2

Overview
TA-SB500WR2 SERVICE MANUAL Ver.
1.
0 2007.
03 US Model • TA-SB500WR2 is the surround amplifier section in DAV-HDX267W/HDX501W.
SPECIFICATIONS AUDIO POWER SPECIFICATIONS POWER OUTPUT AND TOTAL HARMONIC DISTORTION: With 3 ohms loads, both channels driven, from 120 Hz - 20,000 Hz; rated 60 watts per channel minimum RMS power, with no more than 0.
7 % total harmonic distortion from 250 milli watts to rated output.
Power requirements: Power consumption Dimensions (approx.
) 120 V AC, 60 Hz On: 40 W 65 × 89 × 253 mm (2 5/8 × 3 5/8 × 10 inches) (w/h/d) 65 × 89 × 345 mm (2 5/8 3 × 5/8 × 13 5/8 inches) (w/h/d) incl.
speaker cord cover 1.
3 kg (2 lb 14 oz) 1.
4 kg (3 lb 2 oz) incl.
speaker cord cover Mass (approx.
) Amplifier section Surround mode (reference) RMS output power SL/SR* : 100 W (per channel at 3 ohms, 1 kHz, 10 % THD) * Depending on the sound field setting and the source, there may be no sound output.
Design and specifications are subject to change without notice.
SURROUND AMPLIFIER 9-887-591-01 2007C05-1 © 2007.
03 Sony Corporation Home Audio Division Published by Sony Techno Create Corporation http://www.
Datasheet4U.
com TA-SB500WR2 Notes on chip component replacement • Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be damaged by heat.
UNLEADED SOLDER Boards requiring use of unleaded solder are printed with the leadfree mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with the lead free mark due to their particular size) : LEAD FREE MARK Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher than ordinary solder.
Ordinary soldering irons can be used b ut the iron tip has to be applied to the solder joint for a slightly longer time.
Soldering irons using a temperature re gulator should be set to about 350 °C.
Caution: The printed pattern (copper foil) may peel a way if the heated tip is applied ...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)