DatasheetsPDF.com

ACE605

ACE
Part Number ACE605
Manufacturer ACE
Description Ultra Low Dropout 2A CMOS LDO
Published Jun 17, 2014
Detailed Description ACE605 Ultra Low Dropout 2A CMOS LDO Description The ACE605 series are high performance linear voltage regulators that p...
Datasheet PDF File ACE605 PDF File

ACE605
ACE605

Overview
ACE605 Ultra Low Dropout 2A CMOS LDO Description The ACE605 series are high performance linear voltage regulators that provide ultra low-dropout voltage, high output current in lowest output voltage.
It operates from an input of 1.
4V to 5.
5V and provides output current up to 2A thus is suitable to drive digital circuits requiring low voltage at high currents.
The ACE605 has superior regulation over variations in line and load.
Also it provides fast respond to step changes in load.
Other features include over-current and overtemperature protection.
The adjustable version has enable pin to reduce power consumption in shutdown mode.
The devices are available ADJ output , and via exteral R adjust output voltage from 0.
6V to Vin-0.
3V, 0.
6V is the reference voltage.
The BM9165 have enable function, that is good for poratble system for main chip on and off.
In order to have lower dropout and bigger current output Ven should 0.
8~1.
0V higher than Vin, but can work if same.
Power pad sop8 can output over 2A and 1.
6A without the pad.
Features  300mV Dropout @ 2A (1.
2V output)  <300μA Low Ground Pin Current  Excellent Line and Load Regulation  0.
1μA Quiescent Current in Shutdown Mode  Guaranteed >2A Output Current  Fixed Output Voltages: 1.
05V, 1.
2V, 1.
8V, 2.
5V  Adjustable Output Voltage from 0.
6V to 4.
5V  Over-Temperature/Over-Current Protection Application  Card reader and Battery-Powered Equipment  Mother Board/Graphic Card  LCD-TV , NET BOOK , USB Net card  NET-BOOK, pin-pin with RT9025, RT9018 Packaging Type SOP-8 VER 1.
3 1 ACE605 Ultra Low Dropout 2A CMOS LDO Description EN VIN Function Chip ENABLE Control Input.
Logic enable On logic 3.
3V/5V.
Note that the device will be in the unstable state if the pin is not connected Supply Input GND Common Ground VOUT ADJ Regulator Output The output voltage is set by the internal feedback resistors when this pin grounded.
If external feedback resistors are applied, the output voltage will be: Vout=0.
6*(1+R1/R2)Volt...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)