DatasheetsPDF.com

KPEG1501

Kingstate
Part Number KPEG1501
Manufacturer Kingstate
Description Piezo Siren
Published Nov 21, 2014
Detailed Description A. SCOPE This specification applies piezo audio siren, KPEG1501 KPEG1501 B. SPECIFICATION No. Item 1 Operating Freque...
Datasheet PDF File KPEG1501 PDF File

KPEG1501
KPEG1501

Overview
A.
SCOPE This specification applies piezo audio siren, KPEG1501 KPEG1501 B.
SPECIFICATION No.
Item 1 Operating Frequency 2 Operating Volt.
range 3 Current consumption 4 Sound pressure level 5 Rated Voltage 6 Tone 7 Operating temp.
8 Storage temp.
9 Dimension 10 Weight (MAX) 11 Material 12 Terminal Environmental 13 Protection Regulation Unit KHz VDC mA dB VDC mm gram Specification 2 ~3 .
5 6 ~ 14 MAX.
70 Typical 50 102 12 Siren -10 ~ + 60 -40 ~ + 80 L47.
0 x W39.
0 x H22.
8 27.
0 ABS UL-94 1/16”HB HIGH HEAT (BLACK) Wire type RoHS C.
APPEARANCE DRAWING Condition at 12VDC at 30 cm/12VDC(MIN.
) 10 minutes See appearance drawing See appearance drawing Tol : ± 0.
5 Unit: mm KINGSTATE ELECTRONICS CORP 2/5 KPEG1501 D.
MEASURING METHOD S.
P.
L.
Measuring Circuit Mic : RION S.
P.
L.
meter UC30 or equivalent Mic : RION UC30 E.
VOLTAGE: SOUND PRESSURE LEVEL / VOLTAGE: CURRENT CONSUMPTION CHARACTERISTICS / KINGSTATE ELECTRONICS CORP 3/5 KPEG1501 F.
MECHANICAL CHARACTERISTICS No.
Item Test Condition Evaluation standard Solderability 90% min.
stripped wires shall be Stripped wires of lead wires are immersed in rosin for 5 seconds and wet with solder.
(Except the edge 1 then immersed in solder bath of +270±5 for 3±0.
5 seconds.
(Connector excepted) () 5 , +270±5 3±0.
5 .
of terminal) .
( ) 90% The pull force shall be applied to double lead wire Lead Wire Pull Horizontal 3.
0N(0.
306kg) for 30 seconds.
2 Strength Vertical 2.
0N(0.
204kg) for 30 seconds.
3.
0N(0.
306kg) , No damage and cutting off.
,.
2.
0N(0.
204kg) , 30 .
Buzzer shall be measured after being applied vibration of amplitude of The value of oscillation 3 Vibration 1.
5mm with 10 to 55hz band of vibration frequency to each of 3 frequency/ current consumption per-pendicular directions for 2 hours.
should be in ±10% compared 10 55HZ 1.
5mm X.
Y.
Z 3 , 2 .
with initial ones .
The SPL should be in ±10dB compared with 4 Drop test The part only shall be dropped from a height of 75cm onto a 40mm thic...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)