DatasheetsPDF.com

25P10

STMicroelectronics
Part Number 25P10
Manufacturer STMicroelectronics
Description 1 Mbit Low Voltage Paged Flash Memory
Published Dec 2, 2015
Detailed Description M25P10 1 Mbit Low Voltage Paged Flash Memory With 20 MHz Serial SPI Bus Interface PRELIMINARY DATA s 1 Mbit PAGED Flash...
Datasheet PDF File 25P10 PDF File

25P10
25P10

Overview
M25P10 1 Mbit Low Voltage Paged Flash Memory With 20 MHz Serial SPI Bus Interface PRELIMINARY DATA s 1 Mbit PAGED Flash Memory s 128 BYTE PAGE PROGRAM IN 3 ms TYPICAL s 256 Kbit SECTOR ERASE IN 1 s TYPICAL s BULK ERASE IN 2 s TYPICAL s SINGLE 2.
7 V to 3.
6 V SUPPLY VOLTAGE s SPI BUS COMPATIBLE SERIAL INTERFACE s 20 MHz CLOCK RATE AVAILABLE s SUPPORTS POSITIVE CLOCK SPI MODES s DEEP POWER DOWN MODE (1 µA TYPICAL) s ELECTRONIC SIGNATURE s 10,000 ERASE/PROG CYCLES PER SECTOR s 20 YEARS DATA RETENTION s –40 TO 85°C TEMPERATURE RANGE DESCRIPTION The M25P10 is an 1 Mbit Paged Flash Memory fabricated with STMicroelectronics High Endurance CMOS technology.
The memory is accessed by a simple SPI bus compatible serial interface.
The bus signals are a serial clock input (C), a serial data input (D) and a serial data output (Q).
The device connected to the bus is selected when the chip select input (S) goes low.
Data is clocked in during the low to high transition of clock C, data 8 1 SO8 (MN) 150 mil width 8 1 SO8 (MW) 200 mil width Figure 1.
Logic Diagram VCC Table 1.
Signal Names C Serial Clock D Serial Data Input Q Serial Data Output S Chip Select W Write Protect HOLD Hold VCC Supply Voltage VSS Ground D C S W HOLD M25P10 VSS Q AI03744 June 2000 This is preliminary information on a new product now in development or undergoing evaluation.
Details are subject to change without notice.
1/21 M25P10 Figure 2.
SO Connections S Q W VSS M25P10 18 27 36 45 AI03745 VCC HOLD C D is clocked out during the high to low transition of clock C SIGNALS DESCRIPTION Serial Output (Q) The output pin is used to transfer data serially out of the memory.
Data is shifted out on the falling edge of the serial clock.
Serial Input (D) The input pin is used to transfer data serially into the device.
It receives instructions, addresses, and the data to be programmed.
Input is latched on the rising edge of the serial clock.
Serial Clock (C) The serial clock provides the timing of t...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)