DatasheetsPDF.com

LTC1041

Linear Technology
Part Number LTC1041
Manufacturer Linear Technology
Description BANG-BANG Controller
Published Mar 22, 2005
Detailed Description U U FEATURES s Micropower 1.5µW (1 Sample/Second) s Wide Supply Range 2.8V to 16V s High Accuracy Guaranteed SET POINT ...
Datasheet PDF File LTC1041 PDF File

LTC1041
LTC1041

Overview
U U FEATURES s Micropower 1.
5µW (1 Sample/Second) s Wide Supply Range 2.
8V to 16V s High Accuracy Guaranteed SET POINT Error ±0.
5mV Max Guaranteed Deadband ±0.
1% of Value Max s Wide Input Voltage Range V+ to Ground s TTL Outputs with 5V Supply s Two Independent Ground-Referred Control Inputs s Small Size 8-Pin SO U APPLICATIO S s Temperature Control (Thermostats) s Motor Speed Control s Battery Charger s Any ON-OFF Control Loop , LTC and LT are registered trademarks of Linear Technology Corporation.
LTCMOS is a trademark of Linear Technology Corporation.
LTC1041 BANG-BANG Controller DESCRIPTIO The LTC®1041 is a monolithic CMOS BANG-BANG controller manufactured using Linear Technology’s enhanced LTCMOS™ silicon gate process.
BANG-BANG loops are characterized by turning the control element fully ON or fully OFF to regulate the average value of the parameter to be controlled.
The SET POINT input determines the average control value and the DELTA input sets the deadband.
The deadband is always 2 x DELTA and is centered around the SET POINT.
Independent control of the SET POINT and deadband, with no interaction, is made possible by the unique sampling input structure of the LTC1041.
An external RC connected to the OSC pin sets the sampling rate.
At the start of each sample, internal power to the analog section is switched on for ≈ 80µs.
During this time, the analog inputs are sampled and compared.
After the comparison is complete, power is switched off.
This achieves extremely low average power consumption at low sampling rates.
CMOS logic holds the output continuously while consuming virtually no power.
To keep system power at an absolute minimum, a switched power output (VP-P) is provided.
External loads, such as bridge networks and resistive dividers, can be driven by this switched output.
The output logic sense (i.
e.
, ON = V+) can be reversed (i.
e.
, ON = GND) by interchanging the VIN and SET POINT inputs.
This has no other effect on the operation of the LTC1041.
T...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)