DatasheetsPDF.com

K8006

ETC
Part Number K8006
Manufacturer ETC
Description BASE UNIT
Published Jul 23, 2007
Detailed Description Total solder points: 234 Difficulty level: beginner 1o 2o 3o 4o 5þ advanced BASE UNIT for HOME MODULAR LIGHT Features :...
Datasheet PDF File K8006 PDF File

K8006
K8006

Overview
Total solder points: 234 Difficulty level: beginner 1o 2o 3o 4o 5þ advanced BASE UNIT for HOME MODULAR LIGHT Features : SYSTEM K8006 Create your own domestic modular light control system For use with optional plug-in dimmer module (K8007) and plug-in timer module (K8008) þ Bus system holds up to five plug-in units þ Optically insulated push button inputs þ Can be controlled with open collector circuits (ex.
K8000 computer inter face card or with IR remote control receiver K6711) þ Local control pushbuttons included þ LED power and mains indicator þ LED operation indicator for each channel þ Low-voltage control circuit for extra safety þ Each plug-in slot is fused þ Includes 10 LED’s for pushbutton illumination www.
DataSheet4U.
com þ A custom enclosure for rail mounting is available (B8006) þ þ þ þ þ þ þ þ þ Specifications : Five separate channels Maximum output : 2.
5A per channel (fuse protected) Push button control current: 150mA Open collector control current: 35mA DC Power supply: 24VAC / 300mA Supply voltage for modules: 110V to 240VAC PCB dimensions: 107 x 160 x 70mm/ 4.
2”x6.
3”x2.
8” modifications reserved ILLUSTRATED ASSEMBLY MANUAL H8006IP-ED2 VELLEMAN COMPONENTS Legen Heirweg 33 9890 Gavere Belgium http://www.
velleman.
be Assembly hints 1.
Assembly (Skipping this can lead to troubles ! ) Ok, so we have your attention.
These hints will help you to make this project successful.
Read them carefully.
1.
1 Make sure you have the right tools: • A good quality soldering iron (25-40W) with a small tip.
• Wipe it often on a wet sponge or cloth, to keep it clean; then apply solder to the tip, to give it a wet look.
This is called ‘thinning’ and will protect the tip, and enables you to make good connections.
When solder rolls off the tip, it needs cleaning.
• Thin raisin-core solder.
Do not use any flux or grease.
• A diagonal cutter to trim excess wires.
To avoid injury when cutting excess leads, hold the lead so they cannot fly towards the eyes.
• Needle nose pl...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)