DatasheetsPDF.com

8T49N241

Renesas
Part Number 8T49N241
Manufacturer Renesas
Description NG Universal Frequency Translator
Published Sep 26, 2023
Detailed Description FemtoClock® NG Universal Frequency Translator 8T49N241 Datasheet Description The 8T49N241 has one fractional-feedback ...
Datasheet PDF File 8T49N241 PDF File

8T49N241
8T49N241

Overview
FemtoClock® NG Universal Frequency Translator 8T49N241 Datasheet Description The 8T49N241 has one fractional-feedback PLL that can be used as a jitter attenuator and frequency translator.
It is equipped with one integer and three fractional output dividers, allowing the generation of up to four different output frequencies, ranging from 8kHz to 1GHz.
These frequencies are completely independent of each other, the input reference frequencies, and the crystal reference frequency.
The device places virtually no constraints on input to output frequency conversion, supporting all FEC rates, including the new revision of ITU-T Recommendation G.
709 (2009), most with 0ppm conversion error.
The outputs may select among LVPECL, LVDS, HCSL or LVCMOS output levels.
This makes it ideal to be used in any frequency synthesis application, including 1G, 10G, 40G and 100G Synchronous Ethernet, OTN, and SONET/SDH, including ITU-T G.
709 (2009) FEC rates.
The 8T49N241 accepts up to two differential or single-ended input clocks and a fundamental-mode crystal input.
The internal PLL can lock to either of the input reference clocks or just to the crystal to behave as a frequency synthesizer.
The PLL can use the second input for redundant backup of the primary input reference, but in this case, both input clock references must be related in frequency.
The device supports hitless reference switching between input clocks.
The device monitors both input clocks for Loss of Signal (LOS), and generates an alarm when an input clock failure is detected.
Automatic and manual hitless reference switching options are supported.
LOS behavior can be set to support gapped or un-gapped clocks.
The 8T49N241 supports holdover.
The holdover has an initial accuracy of ±50ppB from the point where the loss of all applicable input reference(s) has been detected.
It maintains a historical average operating point for the PLL that may be returned to in holdover at a limited phase slope.
The PLL has a register-sele...


Similar Datasheet


@ 2014 :: Datasheetspdf.com :: Semiconductors datasheet search & download site. (Privacy Policy & Contact)